User's Manual

[212] Cellular Receiver 2 DNIS
Default (000000)
Valid range: 000000 - 0FFFFF.
[213] Cellular Receiver 2 Address
Default (000.000.000.000)
Valid segment range: 000-255
[214] Cellular Receiver 2 Port
Default (0BF5/3061) Valid range: 0000 - FFFF.
[215] Cellular Receiver 2 APN
Default ( ) 32 ASCII characters.
____________________________________
[216] Cellular Receiver 2 Domain Name
Default ( ) 32 ASCII characters.
Programming not permitted on UL/ULC listed system.
____________________________________
Cellular Options
[221] Cellular Public Access Point Name
Default ( ) 32 ASCII characters
____________________________________
[222] Cellular Login User Name
Default ( ) 32 ASCII characters.
____________________________________
[223] Cellular Login Password
Default ( ) 32 ASCII characters.
____________________________________
[224] Cellular Test Transmission Time of Day
Default (9999) Valid range: 00 - 23 hrs. (HH) 00 - 59 min.
(MM).
[225] Cellular Test Transmission Cycle
Default (000000)
Valid range: 000000 - 999999 minutes.
[226] Network Trouble Delay
Default (0F)
Valid entries from,00 to FF.
Command and Control Options
[301] Command and Control Toggle Options
[1] Reserved
[2] Reserved
[3] SMS Command and Control Default (ON).
[4] Reserved
[5] SMS Character Format (OFF)
[6] Long SMS Message Handling Default (OFF).
[7] Reserved
[8] Reserved
[311]-[318] SMS Phone Number 1-8
This section may be programmed through DLS-IV or the
keypad.
______________________________________________
[321]-[328] SMS Phone Number 1-8 Toggle
Options
[1] SMS Notification Alarm/Restore Default (OFF).
[2] SMS Notification Tamper/Restore Default (OFF)
[3]SMSNotificationOpening/ClosingDefault(OFF).
[4] SMS Notification System Maintenance Default
(OFF)
[5] SMS Notification System Test Default (OFF)
[6] SMS Notification Internal Events Default (OFF).
[7] SMS Notification Enabled Default (OFF).
[8] SMS Command and Control Enabled Default
(ON).
[601] Stay Arm
Default (Stay Arm)
Send this command to the system to stay arm.
______________________________________________
[602] Away Arm
Default (Away Arm)
Send this command to the system to away arm.
______________________________________________
[603] Night Arm
Default (Night Arm)
Send this command to the system to night arm.
______________________________________________
[604] Disarm
Default (Disarm)
Send this command to the system to disarm.
______________________________________________
[605]-[608] Activate Command Output 1-4
Default (Activate Command Output n)
Send this command to the system to activate a command out-
put.
______________________________________________
[609]-[612] Deactivate Command Output 1-4
Default (Deactivate Command Output n)
Send this command to the system to deactivate a command
output.
______________________________________________
[613] Bypass
Default (Bypass)
Send this command to the system to bypass a zone.
______________________________________________
[614] Unbypass
Default (Unbypass)
Send this command to the system to unbypass a Zone.
32