User's Manual

4
2. Mount the cabinet securely to the wall using the supplied 3 (three) screws.
Figure: 2.2 Mounting the HSM2HOST
2.4 Other Options
The following actions may be performed on the HSM2HOST, as well as other optional
modules.
2.4.1 [751] Delete Module
To remove a module from the alarm panel:
1. Enter the following Installer Programming section:
[751] (Delete Module) > Select module type: see Table 2-1 on page 3.
2. When prompted, press [*]. The module is deleted from the system.
2.4.2 [752] Confirm Module
This feature is used to confirm that a module is operational and also to help identify a spe-
cific module when more that one of the same type is enrolled.
To confirm a module:
1. Enter the following Installer Programming section:
[752] (Confirm Module) > Select module type: see Table 2-1 on page 3.
2. When prompted, press [*]. The module serial number is displayed on the keypad and
the red LED on the module flashes.
3. Press [#] to exit.
2.4.3 [753] Module Labels
To add a label to a module:
1. Enter the following Installer Programming section:
[753] (Module Labels) > Select module type: see Table 2-1 on page 3.
2. When prompted, key in a label to identify the module.
3. Press [#] to label another module or [#][#] to exit.
2.4.4 [804] Enroll Wireless Devices
Once the HSM2HOST is installed and enrolled on the alarm panel, wireless devices can be
enrolled using one of the following methods:
Auto enroll (use to enroll devices during installation):
1. Enter the following Installer Programming section:
[804] (Wireless Programming) > [000] (Add Wireless Devices)
2. Press [*]. When prompted, activate the device (see device installation sheet).
Placeholder Image
Not actual Product