User's Manual

Full enrollment

To enroll the HSM2HOST after initial startup of the alarm panel:

1. Enter the following Installer Programming section:

[750] (Enroll Module) > [000] (Auto Enroll All Modules)

When prompted, activate the HSM2HOST by pressing the tamper button.

2. Press [*]. The module is enrolled into the next available slot for the device.

3. Continue the above procedure until all modules are enrolled.

Pre-enrollment

Pre-enrollment consists of two parts:

1) Prior to installation, program the electronic serial number (ESN) of all modules and

select configuration options.

2) At the installation site, activate the module.

To pre-enroll the HSM2HOST or another module:

1. Enter the following Installer Programming section:

[750] (Enroll Module) > [001] (Modules)

2. Select a module type using the scroll keys or by entering the appropriate hotkey.

Table 2-1 Available Modules

3. When prompted, key in the serial number found on the back of the device. The mod-

ule is enrolled.

4. At the installation site, activate each module. The alarm panel does not have to be in

Installer Programming mode.

2.2 Test HSM2HOST Location for RF Interference

The HSM2HOST performs best in locations where RF interference is minimal. To find a

suitable mounting location:

• With the alarm panel powered up and the HSM2HOST enrolled, observe the status of

the green LED. If the LED is on, interference levels are high and a new mounting

location should be found. If the green LED is flashing or off, interference is low

and the location is good.

2.3 Permanently Mount

Once a suitable location is found, mount the HSM2HOST as follows:

1. Pull the Corbus wires through the holes at the back of the cabinet.

Hotkey Module Type

001 Keypads

002 Zone Expander

003 Output Module

006 HSM2Host

008 Audio Verification Module

009 Power Supply 1A