User's Manual

3G Alarm Communicator Installlation Manual Command and Control Options

[222] Cellular Login User Name

Default ( )

Some network carriers require you to provide login credentials when connecting to an APN. Program your login User Name in this Sec-

tion. Format is up to 32 ASCII characters.

NOTE: This Section is not accessible via SCW keypad programming.

[223] Cellular Login Password

Default ( )

Some network carriers require you to provide login credentials when connecting to an APN. Program your login Password in this Sec-

tion.

Format is up to 32 ASCII characters.

[224] Cellular Test Transmission Time of Day

Default (9999)

Enter a 4 digit value using the 24-hour clock format (HHMM) to set the test transmission time of day. Valid range: 00-23 for the hours

(HH) and 00-59 for the minutes (MM).

NOTE: To disable the test transmission time of day enter 9999 or FFFF in this Section.

The internal date and time will be automatically programmed by the primary receiver only.

[225] Cellular Test Transmission Cycle

Default (000000)

This value represents the interval in between test transmissions in minutes. Valid range: 000000 - 999999 minutes. Once the unit has

sent the initial periodic test transmission, all future test transmissions will be offset by the programmed number of minutes. See Sec-

tions [026] - [029].

NOTE: Minimum value is 000005 minutes. Programming an interval that is less than 5 minutes will disable test transmission.

[226] Cellular Trouble Delay

Default (00)

This option is used to program the delay, in minutes, for reporting a Cellular Trouble Delay. Valid entries are 00 - FF. (e.g., for a 10 min-

ute Cellular Trouble Delay enter: 0A). There is no reporting delay if value is programmed as 00.

COMMAND AND CONTROL OPTIONS

[301] Command and Control Toggle Options

[1] SMS Notification Default (ON).

[2] Reserved Default ( ).

[3] SMS Command and Control Default (ON).

[4] Reserved Default ( ).

[5] SMS Character Format Default.

ON: SMS Unicode, maximum message length is 70 characters.

OFF: 7 bit SMS, maximum message length is 160 characters.

[6] Long SMS Message Handling Default (OFF).

ON: If longer than maximum message length, it is split and sent as multiple SMS messages.

OFF: If longer than maximum message length, a single, truncated SMS message is sent.

[7-8] Reserved Default ( ).

Table 9: Cellular Test Transmission Interval

Test Transmission Interval Daily Weekly Monthly

Programmed Minutes 001440 010080 043200