User's Manual

3
entering the access code at the time of disarming the alarm system) or it will be reset automati-
cally after 48 hours with no trips on any zones.
NOTE: (*) The SMS features was not investigated by UL/ULC.
Keypad Controls & Indicators
IMPORTANT NOTICE
A security system cannot prevent emergencies. It is only intended to alert you and your central
station (if applicable) to an emergency situation. Security systems are generally very reliable
but they may not work under all conditions and they are not a substitute for prudent security
practices or life and property insurance. Your security system must be installed and serviced by
qualified security professionals. These professionals can instruct you on the level of protection
that has been provided and on system operations.
NOTE: When the keypad is in Sleep Mode it is saving battery life e.g., backlighting, LCD
message display will not be turned on until there is a specific reason: a key is pressed, entry
delay is started. In this mode the keypad is still functioning and nothing will be visible; however
if desired, your installer can enable the product to show the armed status while in Sleep Mode.
Language Selection
Your system can display messages in different languages.
1. Press and hold both [<][>] buttons simultaneously for 2 seconds.
2. Using the [<][>] buttons, scroll through the available languages.
3. Press [
] to select your desired language.
Arming and Disarming the System
Stay Arming
Stay arming will bypass the interior protection (i.e., motion sensors) and arm the perimeter of
the system (i.e., doors and windows). Close all sensors (i.e., stop motion and close doors). The
Ready ( ) indicator will illuminate.
Press and hold the Stay button until it beeps (approx. 2 seconds. Enter your access code,
do not leave the premises. During the setting state (Exit Delay active), the Armed ( ) and
Ready ( ) indicators will illuminate.
When the exit delay is completed, the alarm system is armed/set and this is indicated on the
keypad as follows: the Ready ( ) indicator will turn off, the Armed ( ) indicator will remain on.
The Armed ( ) indicator and a bypass message will be displayed. The system will automati-
cally ignore bypassed zones (i.e., motion sensors).
NOTE: Your installer can program a function key on the keypad to allow you to arm the system
in Stay mode instantly. This allows you to activate Stay Arming by holding down the function key
for 2 seconds. The system arms immediately with no beeps sounding and no exit delay. This
feature must not be used in CP-01 installations.
Stay
Away
Chime
Bypass
Exit
3
6
9
#
2
5
8
0
1
4
7
*

LED Indicators
Ready
Armed
Trouble
Power
Function Keys
Away
Arm
Stay
Arm
Chime
Bypass Zones
Quick Exit
X
O
Previous Screen
Selects Option
Scroll Keys
Fire Key
Auxiliary Key
Panic Key
2x16 LCD
<>indicates user can
scroll through options
DRAFT