User's Manual

14
SMS (Short Message Service) Notification
SMS Notification occurs when the control panel sends a text message to the user for each sys-
tem event that occurs. These text messages are limited to 32 characters.
NOTE: SMS Notification is not available in North America.
Interactive SMS allows the user to send a text message (in one of 28 languages, depending on
SMS Interactive language selection) to the control panel and perform a set of functions on the
panel. There are 12 pre-defined text message commands available that the user can send to the
control panel. Please refer to the SMS Reference Card to find the text used for other languages.
NOTE: Interactive SMS is available in North America.
The SMS Notification Sequence
The panel will send an SMS notification for every event that the panel can communicate. SMS
notification messages are programmed by your installer from the keypad or by using DLS IV.
Text messages can be programmed in the language of your choice.
There are 8 SMS phone numbers available to support SMS messages. An SMS phone number
can be changed using [*][6][Master Code]. Refer to the Changing SMS Phone Numbers section
for detailed instructions.
SMS Remote Access Connection Sequence
This feature allows you to control your security system remotely via SMS.
1. Determine which action to perform remotely on the panel. Please refer to the SMS Reference
card for details on how to enter the text required.
All SMS remote access functions require an access code, with the exception of the help function. The
following list is an example of the functions available.
NOTE:
The default text (see SMS Reference card) used to perform each action can be changed for
you by your installer.
2. Compose an SMS message that consists of the function text, a space, and your 4-digit or 6-
digit access code (e.g., “Stay arm”(Function)<space>“2234”(Access Code)) and send it to
your GSM phone number.
3. The panel matches the incoming phone number to one of the phone numbers in its SMS
phone number list.
4. The panel verifies the contents of the SMS message and performs the action.
5. When the action is completed, the panel sends an SMS message containing “function suc-
cessful” back to the user. If the function or access code is invalid, the response will include
“function unsuccessful” in the SMS message.
6. A one hour System Lockout is caused by entering 5 invalid access codes. If you receive the
message “function failed,” the system has locked you out and you must wait one hour before
using SMS remote access, again.
On-board LCD Display SMS Messages
In addition to function commands, you can also send general SMS messages from your mobile
phone that can be displayed on your keypad screen. A 10-second steady tone will sound when
it appears on the keypad display. This message is displayed until you press any button to
clear. The number of key presses required to remove the message is programmed by your in-
staller.
Function
• stay arm • activate command output 2
• away arm • deactivate command output 1
• disarm • deactivate command output 2
• bypass • status request
• unbypass • alarm memory request
• activate command output 1 • help (list of available commands)
DRAFT