User's Manual

ManualsBrandsDigital Security Controls ManualsElectronicsWireless Communication Interface

IT- 410

2 Way Wireless Communicator Interface

Interface sans fil de communicateur de 2 manières

Interfaz sin hilos del comunicador de 2 maneras

v1.0

Installation Sheet

Feuille d’installation

Hoja de instalación

The IT- 410 provides an interface to 3

party equipment that can communicate with the ALEXOR via two-way RF interface.

IT- 410 is connected to the 3

party device via a USB connection to the Xanboo Gateway. Environmental specifications are

provided in Table 1 at the end of this document.

Spanish Translation Here

French Translation Here

Note: The Xanboo Gateway is a 3

Party device. It must be installed and operating before starting installation of the IT- 410.

Nota: Spanish Translation goes here.

Note: French Translation goes here.

(b)

IT- 410

Xanboo

Gateway

(c)

(a)

ALEXOR

DG0009498

(Maximum 100’)

Figure 1: IT- 410 Interconnection

Figure 1: IT- 410 Interconnexion

Figura 1: IT- 410 Interconexión

Summary of content (8 pages)

PAGE 1
IT- 410 2 Way Wireless Communicator Interface Interface sans fil de communicateur de 2 manières Interfaz sin hilos del comunicador de 2 maneras Figure 1: IT- 410 Interconnection Figure 1: IT- 410 Interconnexion Figura 1: IT- 410 Interconexión ALEXOR (Maximum 100’) IT- 410 (c) (b) DG0009498 (a) Xanboo Gateway The IT- 410 provides an interface to 3rd party equipment that can communicate with the ALEXOR via two-way RF interface.
PAGE 2
IT- 410 PRE INSTALLATION CAUTIONS CAUTION: The IT- 410 shall be installed by Service Persons only. Service Person is defined as a person having the appropriate technical training and experience necessary to be aware of hazards to which that person may be exposed in performing a task and can also take measures to minimize the risks to that person or other persons.
PAGE 3
IT- 410 PLACEMENT TEST 1. 2. 3. 4. Place the IT- 410 in the intended mounting location. At the primary keypad, enter *8[898] [905]. (Individual Device Placement Test). Observe Select Device for Test < > is displayed. Enter the two digit slot number fromstep 4 d. above. Observe Activate Device for Test is displayed. At the IT- 410, press the Enrollment switch and observe result on the keypad LCD: a.
PAGE 4
LIMITED WARRANTY Digital Security Controls (DSC) warrants the original purchaser that for a period of twelve (12) months from the date of purchase, the product shall be free of defects in materials and workmanship under normal use. During the warranty period, Digital Security Controls shall, at its option, repair or replace any defective product upon return of the product to its factory, at no charge for labour and materials.
PAGE 5
GARANTIE LIMITÉE La société Digital Security Controls garantit le produit contre toutes défectuosités matérielles et d’assemblage dans des conditions normales d’utilisation, à l’acheteur original, pendant une période de douze mois à partir de la date d’achat. Dans l’application de cette garantie, la société Digital Security Controls s’engage, à son choix, à réparer ou à remplacer tout matériel défectueux dès son retour à un dépôt de réparation, sans frais de main d’oeuvre et matériels.
PAGE 6
IMPORTANTE – LEA ATENTAMENa TE: el Software DSC comprado con o sin Productos y Componentes tiene marca registrada y es adquirido bajo los siguientes términos de licencia: • Este Acuerdo de Licencia de Usuario Final (End-UserLicense Agreement — “EULA”) es un acuerdo legal entre Usted (la compañía, individuo o entidad que ha adquirido el Software y cualquier Hardware relacionado) y Digital Security Controls, una división de Tyco Safety Products Canada Ltd.
PAGE 7
(f) Résiliation — Sous réserve de tous ses autres droits, DSC se réserve le droit de résilier ce CLU si Vous ne respectez pas les modalités de ce CLU. Dans ce cas, Vous devez détruire toutes les copies du PRODUIT LOGICIEL et toutes ses parties composantes. (g) Marques de commerce — Ce CLU ne Vous donne aucun droit relativement aux marques de commerce ou aux marques de service de DSC ou de ses fournisseurs. 3.
PAGE 8
FCC Compliance Statement CAUTION: Changes or modifications not expressly approved by the manufacturer could void your authority to use this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.