User's Manual

ManualsBrandsDigital Security Controls ManualsElectronicsGSM ALARM COMMUNICATOR FOR DSC POWER SERIES PANELS

System Options

[001] Ethernet IP Address

Default (000.000.000.000)

|____|____|____||____|____|____||____|____|____|____|____|____|

[002] Ethernet IP Subnet Mask

Default (255.255.255.000)

|____|____|____||____|____|____||____|____|____|____|____|____|

[003] Ethernet Gateway IP Address

Default (000.000.000.000);

|____|____|____||____|____|____||____|____|____|____|____|____|

[004] Receiver Supervision Interval

Default (0087/135) Valid range: 0000 - FFFF.

|____|____|____|____|

[005] System Toggle Options

|____| [1] Ethernet Receiver 1 Supervised Default (OFF).

|____| [2] GPRS Receiver 1 Supervised Default (OFF).

|____| [3] Supervision Type Default (OFF).

|____| [4] Primary Communications Path.

Default [OFF] TL260GS-RS; [ON]GS2060-RS.

|____| [5] Redundant Communications Default (OFF).

|____| [6] Remote Firmware Upgrade Default (ON).

|____| [7] Alternate Test Transmission Default (OFF).

|____| [8] GSM Low Signal Trouble Default (OFF).

[006] System Toggle Options 2

|____| [1] Ethernet Receiver 1 Enabled Default (ON).

|____| [2] Ethernet Receiver 2 Enabled Default (ON).

|____| [4] GPRS Receiver 1 Enabled Default (ON).

|____| [5] GPRS Receiver 2 Enabled Default (ON).

|____| [7] DLS Over GPRS Default (ON).

|____| [8] Interactive Over GPRS Default (ON).

[007] DNS Server IP 1



Programming not permitted on UL/ULC listed system.

Default (000.000.000.000)

|____|____|____||____|____|____||____|____|____|____|____|____|

[008] DNS Server IP 2



Programming not permitted on UL/ULC listed system.

Default (000.000.000.000)

|____|____|____||____|____|____||____|____|____|____|____|____|

[009] Language

Default (01)

Label language 01 -29. Valid range: See Table 8.

|____|____|

[010] System Toggle Options 3

|____|

[1] 2 Way Audio over GSM.

Default (OFF).|

Programming Options

[011] Installer Code

Default (CAFE) Valid range: 0000 - FFFF.

|____|____|____|____|

[012] DLS Incoming Port

Default (0BF6/3062); Valid range: 0000 - FFFF.

|____|____|____|____|

[013] DLS Outgoing Port

Default (0BFA/3066) Valid range: 0000 - FFFF.

|____|____|____|____|

[020] Time Zone

Default (00) Valid range: 00 - FF.

|____|____|

[021] Account Code

Default (FFFFFF)

Valid range: 000001 - FFFFFE.

|____|____|____|____|____|____|

[022] Communications Format

Default (04) Program 03 (CID), 04 (SIA).

|____|____|

[023] Panel Absent Trouble

Default (FF) ; Program 00 disable or FF enable.

|____|____|

[024] Panel Absent Trouble Restore