User's Manual

3
When the interior zones are activated (i.e., ) you must enter your access code to disarm
the system to gain access to interior areas that have not been programmed as night zones.
Silent Exit Delay
If the system is armed using the Stay button or using the ’No Entry’ Arming method (
[access code]), the audible progress annunciation (keypad buzzer) will be silenced and the exit
time will be doubled for that exit period only.
Away Arming
Close all sensors (i.e. stop motion and close doors). The Ready ( ) indicator should be on.
To arm, press and hold the Away Button for 2 seconds and/or enter your Access Code, or press
to Quick Arm.
During the setting state (exit delay active) the Armed ( ) and Ready ( ) indicators will turn on,
and the keypad will sound one beep per second. You now have ____ seconds to leave the prem-
ises (please check with your installer to have this time programmed). An audible annunciation,
whose pulsating rate is distinctly different, will sound during the last ten seconds of the exit delay
to warn person(s) that the exit delay is running out. To cancel the arming sequence, enter your
access code or present your prox tag.
When the exit delay is completed, the alarm system is armed and this is indicated on the keypad
as follows: the Ready ( ) indicator will turn off, the Armed ( ) indicator will remain on and the
keypad will stop sounding.
The system can also be armed/disarmed with a wireless key and with proximity tags. Refer to
the ‘Proximity Tags’ and ‘2-Way Wireless Key’ sections on page 9 for more details.
NOTE: If your system is installed in accordance with SIA CP-01 Standard for False Alarm
Reduction then the violation, restoral followed by a second violation of the entry/exit zone before
the end of the exit delay will restart the exit delay.
Quick Exit
If the system is armed and you need to exit, use the Quick Exit function to avoid disarming and
rearming the system. Press and hold the Quick Exit button for 2 seconds or press . You
now have 2 minutes to leave the premises through your exit door. When the door is closed again,
the remaining exit time is cancelled.
Bell/Siren Sounds After Away Arming
Audible Exit Fault
In order to reduce false alar ms, the Audible Exit Fault is designed to notify you of an improper
exit when arming the system. If you fail to securely close the Exit/Entry door during the pro-
grammed exit delay period, the system will sound the alarm to indicate an improper exit (your
installer will tell you if this feature has been enabled on your system). If this occurs:
1. Re-enter the premises.
2. Enter your access code, or present your prox tag, before the entry delay timer expires, to dis-
arm the system.
3. Follow the Away arming procedure again, ensure that the entry/exit door(s) are secured.
Arming Error
An error tone will sound if the system is unable to arm. This will happen if the system is not ready
to arm (i.e. sensors are open), or if an incorrect user code has been entered. If this happens,
ensure all sensors are secure, press and try again.
Disarming
Enter your access code to disarm the system when it is armed (Armed ( ) indicator is on). The
keypad will sound a continuous tone after the entry delay has been initiated by opening the
entry/exit door. Enter your code within _______ seconds to avoid an alarm condition (check with
your installer to have this time programmed).
Disarming Error
If your code is invalid, the system will not disarm and a 2-second error tone will sound. If this
happens, press and try again.



