User's Manual

6
Trouble Conditions
When a trouble condition is detected, the Trouble ( ) indicator will turn on, and the keypad will
beep every 10 seconds. Press the button to silence the beeps. Press to view the
trouble condition. The Trouble ( ) indicator will flash. Use the keys to view troubles.
Alarm Memory
When an alarm occurs, the Alarm Memory message will be displayed. To view which sensor(s)
generated the alarm, press .
For the system keypad use the scroll buttons to view the sensors in alarm memory. Press
to exit. To clear the memory, arm and disarm the system. If an alarm sounded while armed,
the system will automatically go to alarm memory when you disarm the system. In this instance,
you should approach with caution, as the intruder may still be within the building/premises.
Door Chime
To turn the door chime function on or off, press and hold the Chime button for 2 seconds or
press . The system will sound three beeps to indicate the door chime is on or one long
tone to indicate that door chime is off.
Access Code Programming
In addition to the Master Access Code, you can program up to 16 additional User Access codes.
If wireless keys have been programmed then wireless key #1 will log as User Access code #1 (if
that access code has been programmed). User Access codes 1-16 will correspond to wireless
keys or prox tags 1-16. Press , plus your Master Access Code, the armed ( ) indicator
will turn on.
Trouble
Condition
Comments Action
Alternate
Communicator Trouble
I ndicates AC Failure, Low Battery, Sim Card lock, GSM
Trouble, Ethernet Trouble, Central Station Receiver Trouble
, Supervision Config SMS Trouble for GS/IP module if
installed. Press to scroll through troubles.
Call for service.
For Ethernet Trou-
ble Check LAN
connections.
Service Required
(Press [1] for more
information)
Indicates Low Battery, System Trouble, System Tamper or
RF Jam detected.
Call for service.
Loss of AC Power If the building and/or neighbourhood has lost electrical
power, the system will continue to operate on battery for
several hours.
Check AC
connection.
Call for service.
Telephone Line Fault The system has detected that the telephone line is dis-
connected.
Call for service.
Failure to
Communicate
The system attempted to communicate with the monitoring
station but failed. This may be due to a Telephone Line
Fault.
Call for service.
Module/Sensor Fault The system is experiencing difficulties with one or more
module/sensors on the system. Continue to press to
navigate through the Zone, Keypad and Siren fault menus.
Call for service.
Module/Sensor Tamper The system has detected a tamper condition with one or
more module/sensor on the system. Continue to press
to navigate through the Zone, Keypad and Siren
tamper menus.
Call for service.
Module/Sensor Low
Battery
The system has detected a low battery condition with one
or more module/sensor on the system. Continue to press
to display the zone(s), wireless key(s), keypad(s),
siren(s) and prox tag(s).
Call for service.
Loss of Time & Date If complete power was lost (AC and Battery), the time and
date will need to be re-programmed. Press .
Re-program Time
& Date (see page
4).




