User's Manual

ManualsBrandsDigital Security Controls ManualsElectronicsGSM Alarm Communicator

Inputs

The GS3060 has 4 inputs that can be used to trigger specific communications. These events will

transmit using Contact ID format with Input 1-4 reporting as [991] to [994] respectively. Default settings

below:

INPUT 1- FIRE INPUT 3 - BURGLARY

INPUT 2 - PANIC ALARM INPUT 4 - SYSTEM TROUBLE

These inputs are normally open and will activate when a short condition is detected between the

terminal and the COM. Refer to the GS3060 Wiring Diagram (Figure 2) at the back of this manual.

NOTE: When the GS3060 is configured in Land Line Mode, these inputs should be restricted to

monitoring of trouble conditions.

NOTE: These inputs communicate using Contact ID format.

NOTE: For UL/ULC installations, connections between alarm panel outputs and GS3060 inputs

shall be run in mechanical protective conduits. To reduce interference with the antenna, it is

recommended that the metal conduit is not connected to the knock-outs on the top of the

cabinet.

Contact ID Mode

This operating mode will allow the GS3060 to send calls to the Central Station through the GSM

voice channels. The events are also being generated using the four inputs Z1 - Z4.

Alarm signals: require Event Codes and Customer Account Codes Status signal, with a Customer

Account Code

Land Line Status

Power supply Status

Periodic report (to be sent at regular intervals).

The Contact ID reports will be sent when the respective events occur.

The GS3060 can call up to 4 central station numbers, and will call every programmed number on

each event. [Four telephone numbers of up to 20 digits (digits and + signs).]

The GS3060 will try each telephone number 3 times before considering a call unsuccessful and

quitting.

Outputs

The GS3060 has 4 programmable outputs to activate in response to the associated events. Refer to

the GS3060 Wiring Diagram (Figure 2) at the back of this manual.

Activating the Outputs

The GS3060 has 4 open collector outputs capable of a maximum of 50mA. Internal events on the

GS3060 can trigger the outputs to turn on an LED or activate an input on the host panel. The default

settings are as follows:

OUTPUT 1 - Land Line TOUTPUT 1 - Land Line T

OUTPUT 1 - Land Line T

oubleouble

ouble

Output is normally high and will switch to ground when the telephone line is down.

OUTPUT 2 - GSM Model or Network TOUTPUT 2 - GSM Model or Network T

OUTPUT 2 - GSM Model or Network T

oubleouble

ouble

Output is normally high and will switch to ground when the GS3060 can’t connect or communicate

to the GSM network.

OUTPUT 3 - Power Supply or BatterOUTPUT 3 - Power Supply or Batter

OUTPUT 3 - Power Supply or Batter

y Ty T

y T

oubleouble

ouble

Output is normally high and will switch to ground when there is a problem with the power source.

OUTPUT 4 - General Module TOUTPUT 4 - General Module T

OUTPUT 4 - General Module T

oubleouble

ouble

Output is normally low and will switch to high when any of the previous troubles occur and/or a

Failure to Communicate (FTC) trouble is detected.

NOTE: Once an output has been activated automatically, it will not restore its state until all

the causes of activation are cleared.