User's Manual

About Your Security System

Your Security System has been designed to provide you with the greatest possible flexibility and con-

venience. Read this manual carefully and have your installer instruct you on your system's operation

and on which features have been implemented in your system. All users of this system should be

equally instructed in its use. Fill out the “System Information” page with all of your zone information

and access codes and store this manual in a safe place for future reference.

NOTE: The Self Contained Wireless Security System includes specific false alarm reduction fea-

tures and is classified in accordance with ANSI/ SIA CP-01-2000 Control Panel Standard - Fea-

tures for False Alarm Reduction. Please consult your installer for further information regarding

the false alarm reduction features built into your system as all are not covered in this manual.

Fire Detection

This equipment is capable of monitoring fire detection devices such as smoke detectors and provid-

ing a warning if a fire condition is detected. Good fire detection depends on having adequate num-

ber of detectors placed in appropriate locations. This equipment should be installed in accordance

with NFPA 72 (N.F.P.A., Batterymarch Park, Quincey MA 02269). Carefully review the Family Escape

Planning guidelines in this manual.

NOTE: Your installer must enable the fire detection portion of this equipment before it becomes

functional.

Testing

To insure that your system continues to function as intended, you must test your system weekly.

Please refer to the “Testing your System” section in this manual. If your system does not function

properly, call your installing company for service.

Monitoring

This system is capable of transmitting alarms, troubles & emergency information to a central station. If you

initiate an alarm by mistake, immediately call the central station to prevent an unnecessary response.

NOTE: The monitoring function must be enabled by the installer before it becomes functional.

NOTE: This system has a communicator delay of 30 seconds. It can be removed, or it can be in-

creased up to 45 seconds by the installer.

Maintenance

With normal use, the system requires minimum maintenance. Note the following points:

• Do not wash the security equipment with a wet cloth. Light dusting with a slightly moistened cloth

should remove normal accumulations of dust.

• Use the system test described in “Testing Your System” to check the battery condition. We recom-

mend, however, that the standby batteries be replaced every 3-5 years.

• For other system devices such as smoke detectors, passive infrared, ultrasonic or microwave motion

detectors or glassbreak detectors, consult the manufacturer’s literature for testing and maintenance

instructions.

General System Operation

Your security system comprises an integrated alarm control/keypad and various sensors and detec-

tors. The system is mounted by the main exit/entry location. The system is self-contained; electronics,

fuses and standby battery are housed within the keypad unit.

NOTE: Only the installer or service professional should have access to the system.

The security system has several zones of area protection and each of these zones will be connected

to one or more sensors (motion detectors, glassbreak detectors, door contacts, etc.). A sensor in

alarm is indicated by messages on the LCD keypad.

Additional features include: Automatic Inhibit (Swinger Shutdown) for Alarm; Tamper and Trouble

signals after 3 occurrences in a given set period; and a Programmable Keypad Lockout option.