User's Manual
11
Now that you have completed all RF5108-433 related programming, you can test and
install the receiver and devices. See section 5 for more information.
Section 5: Testing & Mounting
5.1 Test the Reception of Wireless Devices
It is very important to test the proposed placement of each wireless device before it is mounted.
Following these steps will test the signal strength between the RF5108-433 and the wireless
devices.
You can test all of the devices together (global placement testing) or test each device
individually. To test all the devices together, see
Testing All Wireless Devices Together
. To test
wireless devices individually, see
Testing Individual Devices
.
Testing All Wireless Devices Together:
1. Temporarily put the wireless devices in the places you want to mount them.
2. At a system keypad, enter [✱][8][Installer’s Code].
3. Enable the Global Module Placement test by entering section [804]. Then enter
sub-section [90] and turn on option [8].
4. Press [#] twice.
5. Enter programming section [904], then enter [01].
6. Activate one of the devices being tested until a result is displayed on the keypad
or sounded by the keypad or bell:
WLS904-433/WLS904PL-433/WLS914-433:
To perform a Placement Test on one of
these devices, remove the detector from the backplate and then replace it. Once the
detector is replaced on the backplate the LED on the detector will flash rapidly 5 times
to indicate that it has sent a transmission. The panel will show and/or sound the result
of the placement test on the keypad. To perform a 2
nd
and 3
rd
test, repeat this
procedure.
Carefully replace the backplate onto the detector, ensuring Carefully replace the backplate onto the detector, ensuring
Carefully replace the backplate onto the detector, ensuring Carefully replace the backplate onto the detector, ensuring
Carefully replace the backplate onto the detector, ensuring
that “TOP”that “TOP”
that “TOP”that “TOP”
that “TOP”
is facing upward, or you may damage the tamper switch.is facing upward, or you may damage the tamper switch.
is facing upward, or you may damage the tamper switch.is facing upward, or you may damage the tamper switch.
is facing upward, or you may damage the tamper switch.
NOTE: When you remove the detector from the backplate (tamper the unit), the detector
will also be put into “Detector Walk Test” mode. While in Walk Test Mode the detector will
activate the LED when motion is detected. The detector will also send a signal to the
receiver 5 seconds after motion is detected, indicated by 5 rapid flashes by the LED. The
LED will only work in this fashion for 10 motion detections after a tamper/restore. Note,
that the panel will ignore these transmission signals with respect to a placement test. The
only way in which the panel will acknowledge a placement test, is if the backplate has,
each time, been removed and restored.
WLS906-433: Remove the detector from its backplate, wait 5 seconds and reattach it, or
hold a magnet near the raised line on the outer rim, then remove it.
WLS907-433/WLS925L-433: Open the contact by moving the magnet away from
the unit. The keypad will show/sound the test result. After the first test result has
been generated (about 10 seconds) close the contact to generate another test
result. If the unit is attached to a door or a window, open and close the door or
window to activate the device.
WLS909-433/WLS919-433: Press any function key at several different locations.
WLS912L-433:
Press and hold the test mode tab for 5 seconds. Release the test
mode tab.
O T H E R P R O G R A M M I N G