User's Manual

Table Of Contents

1 Introduction

The Skyroute CL3050 is a standalone wireless communicator that sends alarm system infor-

mation to

Connect 24

. Connect 24 then forwards this information to the central station.

The Skyroute CL3050 automatically configures itself on power up to one of three opera-

tional modes or; if it is connected to a keypad, in the programming mode. The Skyroute

CL3050 is pre programmed with the most commonly used settings for quick installation. If

required the default options can be custom programmed.

Mode 1: Bell Follower

If the Skyroute CL3050 does not detect a keypad or PC5108 expander card dur-

ing the first 15 seconds of power up, then mode 1 or 2 can be selected by press-

ing the enroll button. The red LED indicates Mode 1 and the yellow LED indicates

mode 2. In Mode 1, the Skyroute CL3050 monitors the

Bell Output

of the con-

trol panel. The system identifies the Bell Output cadence and transmits the corre-

sponding Fire or Burglar alarm reporting code to

Connect 24

Refer to the appropriate

control panel Installation Manual.

Mode 2: 2-Zone

Panel

If Mode 2 is selected during power up the system will configure itself for 2 zone,

stand alone operation with normally closed loops.

Mode 3: 8-Zone Panel

If the Skyroute CL3050 detects a PC5108 expander card on power up it will auto-

matically configure itself for 8-zone standalone operation with normally closed

loops.

Programming Mode

If the Skyroute CL3050 detects a keypad on power up it will go into the program-

ming mode. Programming mode allows the installer to custom program system

options. Refer to Section 5, Programming Descriptions; and Section 6, Program-

ming Worksheets for programming options and default settings.

Note:

The only method of entering the Programming Mode is to power-down the unit,

connect a PowerSeries keypad to the Keybus terminals, then reapply power to

the Skyroute CL3050.

Figure 1