User's Manual

S E C T I O N 2

This section describes how to set up and wire the PC5102-433 module.

2.1 Choose a Mounting Location for the PC5102-433

NOTENOTE

NOTE: Mount the PC5102-433 receiver and wireless keys after you have done

placement tests with the wireless keys (see sections 5.1 and 5.2).

Find a place that is:

• Dry

• Central to the proposed placement of all wireless keys

• As high as possible

• Far from sources of interference, including: electrical noise (computers,

televisions and electric motors in appliances and heating and air

conditioning units); large metal objects like heating ducts and plumbing

which may shield the antenna.

Make sure that electrical wires will not run over the antenna of the module when it is

mounted.

When mounting the PC5102-433 in a basement, place the module as high and as

close to the underside of the first floor as possible. The range of the module will be

reduced if the unit is mounted below ground level.

2.2 Terminal Descriptions

NO1 NC1 COM1 NO2 NC2 COM2 RED BLK YEL GRN

NO1 PGM1 Normally Open Relay Contact

NC1 PGM1 Normally Closed Relay Contact

COM1 PGM1 Relay Common Contact

NO2 PGM2 Normally Open Relay Contact

NC2 PGM2 Normally Closed Relay Contact

COM2 PGM2 Relay Common Contact

RED Keybus Power +12V

BLK Keybus Ground

YEL Keybus Clock

GRN Keybus Data

2.3 Connecting the LED to the PC5102-433

The LED can be used to indicate whether the system is armed or disarmed.

NC2ANT1 GRNYELBLKREDCOM2NO2COM1

NC1NO1

RED

BLACK

PC5102-433 Set Up & Wiring