User's Manual

Additional Notes

S E C T I O N 6

6.1 Trouble Conditions

The control panel always watches for possible trouble conditions. If a trouble

condition occurs, the keypad “Trouble” light will turn on and the keypad will beep.

Press [✱][2] to display the trouble conditions.

The following trouble conditions apply to the PC5102-433 and/or any enrolled wireless

keys.

General System Tamper - This trouble is generated when the PC5102-433

plastic cover is removed.

General System Supervisory - This trouble will be generated if the panel loses

communication with any module connected to the Keybus. The event buffer will

log a detailed description of the event.

Device Low Battery - This trouble is generated when a wireless device exhibits a

low battery condition. Press [7] one, two, or three times to view which devices

are experiencing battery failure. An LED keypad will indicate battery failure

using zone lights 1 to 8.

Tamper Switches

There is one tamper switch on the PC5102-433 board. Removing the plastic cover

will cause a general system tamper.

6.2 Wireless Zone Low Battery Transmission

Within any transmission, the device will indicate the status of the battery. If a battery

is low, the system will indicate a Device Low Battery trouble.

The system will delay reporting the event to the central station for the number of days

programmed for Zone Low Battery Transmission Delay in section [370]. This will

prevent unnecessary reporting of the event if the user has been instructed on how

to replace batteries.

Replacing Batteries in Wireless Devices

1. Remove the cover of the device from its back plate.

2. Refer to the battery installation instructions on the installation sheet of each

component. Be sure to note the proper orientation of the batteries as you

install them.

3. When the fresh batteries are in place, re-attach the cover to the back plate. The

battery trouble will clear when any button is pressed after the installation of

the new batteries, the device should function normally.

NOTENOTE

NOTE: When batteries in one device need to be replaced, the batteries in all de-

vices may need to be replaced at the same time.