User's Manual

4.1 PC5102 PGM Outputs

The PC5102 433 has two on-board Form C Relay PGM outputs. Each of these can

be individually programmed to either:

1. Follow main panel PGM outputs 1 to 14.

NOTE: Please refer to your System Installation Manual for available PGM outputs.

NOTE: If the PC5102-433 is connected to the following panels, PC580/PC1555 all

versions, PC5010 v1.x, WSS5010 1.0, 2.1, PC1565-2P v2.2 or PC5016 v1.x, the PC5102

PGM outputs cannot be programmed to follow main panel PGM outputs 1 or 2.

2. Activate for a programmable amount of time when a data packet is received

from a wireless key programmed with option 31 or 32 and the PGM output

programming section [91] or [92] is programmed with option 15 (PC5102

PGM pulse). The default for the two PGM activation time programming

sections [94] and [95] is 00 minutes and 05 seconds.

3. Toggle state when a data packet is received from a wireless key programmed

with option 31 or 32 and the PGM output programming section [91] or [92] is

programmed with option 16 (PC5102 PGM Toggle).

4.2 Enable PC5102-433 Supervision

The control panel will supervise the PC5102-433 receiver via the Keybus after at least

one key has been enrolled on the module (see section 3.2 “Enrolling Wireless Keys”).

To activate module supervision, after you enroll the first key(s):

1. Exit and then re-enter installer’s programming.

2. Enter programming section [902]. Wait approximately one minute.

3. To exit press [#].

The system will generate a General System Supervisory trouble if the module is

removed from the Keybus. If you need to remove the PC5102-433 module from an

existing system, you will have to disable supervision of the PC5102-433.

NOTENOTE

NOTE: Deleting all wireless keys from the PC5102-433 or defaulting the PC5102-433

will cause a supervisory fault.

To disable PC5102-433 supervision:

1. Disconnect the PC5102-433 from the Keybus

2. Enter [✱][8][Installer Code].

3. Enter [902]. The control panel will clear all supervision and re-scan the system for

connected modules. The scan will take approximately one minute.

4. To exit press [#].

To review which modules the control panel is currently supervising:

1. Enter [✱][8][Installer’s Code]

2. Enter [903] to display all modules. On LED keypads, light [17] will indicate

that the PC5102-433 is present on the system. On LCD keypads, scroll until

the module name appears on the display.

3. To exit press [#].

S E C T I O N 4

Other Programming