User's Manual

ManualsBrandsDigital Security Controls ManualsElectronicsWireless Control receiver

This section describes how to enroll wireless keys (WLS909-433 and WLS919-433). For more

information on these keys, read the instruction sheet included with each key.

3.1 A Note about Electronic Serial Numbers

An electronic serial number (ESN) is printed on the back of each wireless key. ESNs are

used to enroll the wireless keys with the PC5102-433 receiver.

In order to reduce the occurrence of wireless keys with the same serial number, 6-digit

serial numbers are now printed on the back of each wireless key. The 6-digit serial

numbers include hexadecimal digits. For instructions on programming hexadecimal

numbers, see your system

Installation Manual

, Section 4: How to Program.

NOTENOTE

NOTE: 6-digit serial numbers are only supported on the following control panels:

PC5020, PC501X v2.0 and higher, PC1555, PC5008 and PC580.

The WLS909-433 and WLS919-433 keys have both a 5-digit and a 6-digit serial

number printed on them. When connecting the PC5102-433 to a PC5010 v1.x panel,

enter 5-digit serial numbers only. When connecting the PC5102-433 to a PC5020 or

PC5015 v2.x and higher, PC5010 v2.0 and higher, PC1555, PC5008 or PC580 panel

enter the 6-digit serial number.

3.2 Enroll & Program Wireless Keys

For wireless keys to work on the system, you need to enroll them and then program the

function buttons, if the default values are not the functions desired. Wireless keys are

not assigned to zones and require no zone programming. You can enroll up to 8

wireless keys on the system.

Enroll Wireless keys

1. At a system keypad, enter [✱][8][Installer’s code] to go to the Installer’s

Programming section.

2. Enter programming section [804].

3. Enter a 2-digit number [41]-[48] to program the wireless key serial number.

These numbers correspond to wireless key numbers 01- 08.

4. Enter the key’s ESN. The entry

must

be six digits. If an older key with a 5-

digit ESN is being enrolled, add the digit [0] to the beginning of the ESN.

(E.g. ESN=61234, enter 061234)

5. The key is now enrolled on the system. Record the serial number and the

assigned slot number in the programming worksheets in the back of this manual.

6. Repeat steps 3 - 5 until all wireless keys have been enrolled.

((

(

PC5020 / PC5020 /

PC5020 /

PC501PC501

PC501

only) only)

only) By default, all wireless keys are assigned to

Partition 1. To assign keys to Partition 2, enable the appropriate options in

programming section [91].

NOTENOTE

NOTE: A wireless key can only be assigned to one partition.

8. To exit press [#].

Program the WLS909-433 or WLS919-433 Function Buttons

WLS909-433 and WLS919-433 wireless keys have four programmable function

buttons. Default functions have been assigned, but you may program the functions

desired. After the functions are programmed, when you press and hold one of the

four buttons for one second, the system will execute the programmed function.

S E C T I O N 3

Enrolling Wireless Keys