Installation Manual

S E C T I O N 6

Additional Notes

6.1 Trouble Conditions

The control panel always watches for possible trouble conditions. If a trouble

condition occurs, the keypad “Trouble” light will turn on and the keypad will beep.

Press [✱][2] to display the trouble conditions.

The following trouble conditions apply to the receiver portion (identified as the

PC5132 by the panel) and/or any enrolled devices. For a description of all

troubles, please see your system

Installation Manual

• General System Tamper

• General System Supervisory

• Zone Fault

• Device Low Battery

• Zone Tamper

Wireless Zone Low Battery Transmission

Within the supervisory transmission, the device will indicate the status of the

battery. If a battery is low, the system will indicate a Device Low Battery trouble.

The system will delay reporting the event to the central station for the number of

days programmed for Zone Low Battery Transmission Delay in section [370].

This will prevent unnecessary reporting of the event if the user has been instructed

on how to replace batteries.

6.2 Replacing Batteries in Wireless Devices

1 Remove the cover of the device from its backplate. This creates a tamper

condition on the zone.

2 Refer to the battery installation instructions on the

Installation Sheet

of each

component. Be sure to note the proper orientation of the batteries as you

install them.

3 When the fresh batteries are in place, re-attach the cover to the backplate. The

tamper is restored and the zone sends a battery trouble restoral signal to the

receiver. The battery trouble is now clear and the device should function normally.

NOTE: When batteries in one device need to be replaced, the batteries in all

devices should be replaced at the same time.