User Manual

T E S T I N G & M O U N T I N G

Read the test results at the keypad:

Result LED Keypad LCD Keypad Buzzer/Bell

Good Light 1 On Steady “Good” 1 Beep/Squawk

Bad Light 3 On Steady “Bad” 3 Beeps/Squawks

Activate the device until you get 3 good results in a row.

You may mount the WLS devices where results were good.

Devices indicating a bad result must be moved to another location. You may

only have to move the device a few inches to correct a bad result.

NOTE: Do not mount any device where a “bad” test result was indicated.

7. Go to the next device to be tested and activate it until the test result is

displayed/sounded.

NOTE: Wait until the placement test of one device is shown/sounded before begin-

ning to test the next device.

Continue to test the devices until both the PC5132 and the devices are in good

locations. If several wireless devices produce BAD test results, you may need to

move the PC5132 to a better location. (See section 2.2 for tips on finding a

location for the PC5132.)

8. To exit the placement test and return to installer programming, press [#] twice.

Testing Individual Wireless Devices:

1. Temporarily place the wireless device in the place you want to mount it.

2. At a system keypad, enter [✱][8][Installer’s Code].

3. Enter programming section [904].

4 Enter the 2-digit zone number for the device to be tested.

5. Activate the device being tested until a result is displayed on the keypad or

sounded by the keypad or bell. (Same as step 5 in the Global Placement

Test section, previous page.)

6. To test another device, press [#] once, then repeat steps 4 - 5. Continue to test

the devices until both the PC5132 and the devices are in good locations.

If several wireless devices produce BAD test results, you may need to move

the PC5132 to a better location. (See section 2.2 for tips on finding a

location for the PC5132.)

7. To exit the placement test and installer programming, press [#] twice.

Testing Individual Wireless Keys:

You cannot use the individual device test described above to test WLS909-433/

WLS919-433 wireless keys. To ensure that the PC5132 receiver is receiving

transmissions from the devices, use the function keys on the Wireless Keys at

several different points in the installation.