Operating instructions

G3 Series Cleaning and maintenance
Instructions for disposal
7-35
000001,07,12-2008, jmu
7
7.8 Instructions for disposal
Important !
Contact Zünd customer services or your service partner before you dispose of your
cutter.
Zünd cutters are modern industrial devices which correspond with the current
standards and guidelines on the disposal of old appliances.
• Plastic components > 20 grams are labelled and can therefore be disposed of
correctly.
• Steel and plate parts have been varnished with environmentally-friendly varnish
or have been powder-coated. Aluminium components have been anodised. They
can be disposed of as waste metal.
• PCBs have been soldered with lead-free solder and be disposed of as electric
waste.
You must also observe the following:
• Country-specific legislation and regulations on waste disposal.
• No special measures are generally required when decommissioning the cutter
system because no poisonous substances are used.
• Assign a disposal company to remove and recycle the machine correctly.
7.9 Starting up after periods at a standstill
Important !
Before extended periods of downtime/for commissioning of your cutter after periods
at a standstill, contact the Zünd Customer Service department or your service
partner.
In general, the machine can be started up immediately, even after prolonged periods
at a standstill. Some options, however, require running-in routines, which must be
respected in order to ensure further maintenance-free operation.
7.9.1 Vacuum generator 1-9 KW/1-15 KW
Running-in routine after periods at a standstill > 6 days:
⇨ Activate all vacuum zones
⇨ Run in the vacuum unit for approx. 4 minutes at level 1
⇨ followed by approx. 4 minutes at level 2
✓ The vacuum generator is ready for operation