Operating instructions

G3 Series Cleaning and maintenance
Steps for maintenance
7-7
000001,07,12-2008, jmu
7
 Check alignment of toothed/steel belt and readjust if necessary
 Check tension of toothed/steel belt and readjust if necessary
 Check the belt tension
 Replace V-belt
 Clean and lubricate the gears
Module carriage
 Check clearance, replace bearing if necessary
 Lubricate bearing 7.7.8
 Replace wiper
Vacuum generator 1-9 KW/1-15 KW
 Check correct functioning
 Clean filter
 Conveyor
replacement
Check piping for damage and tightness
 6000 B ☟ General inspection
Compressor *
 Check the oil level, if necessary top up oil according to specifications
Refer to the manufacturer's operating manual
 Check water separator and drain water if necessary
 Drain condensate from air cylinder
 Check pressurised pipes for leaks – eliminate any faults
 Check air intake filter, replace if clogged
 Clean compressor
 Check piping for damage and tightness
 Check the function of the safety valve, adjust if necessary
 Replace compressor oil
Maintenance unit
 Drain condensation water 7.7.11
Maintenance/inspection
during operating hours
Work to be carried out
Daily Weekly Monthly Annually (2000 h) Special intervals
By personnel
z One-off activity
 Repetitive interval
 If necessary
By authorised maintenance personnel
{ One-off activity
 Repetitive interval
 If necessary
Chapter