Operating instructions

Cleaning and maintenance G3 Series
Steps for maintenance
7-6
000001,07,12-2008, jmu
7
Maintenance/inspection
during operating hours
Work to be carried out
Daily Weekly Monthly Annually (2000 h) Special intervals
By personnel
z One-off activity
 Repetitive interval
 If necessary
By authorised maintenance personnel
{ One-off activity
 Repetitive interval
 If necessary
Chapter
General
 Visually check the machine for damage
 Free the machine of dust and processing residue
 Check electrical equipment (options) to ensure they function
 Check correct functioning of the emergency stop switch
 Check all safety devices (correct functioning of light barriers, protective trip
switch)
Table complete
 Check all screw connections and tighten according to requirements if
necessary
 Check levelling
 Check feed system*
 Check cabling/wiring and cable routing for signs of wear
Vacuum plate
 Conveyor
replacement
Check levelling and adjust if required
 Check the correct functioning of the vacuum zone control
Bar
 Check perpendicularity and align if required
 Check length compensation and adjust if required
Feeding options
 Clean rubber cushions/needle cushions* of the feed elements 7.7.10
 Clean feed guide rail 7.7.10
 Clean and oil feeding clamp piston rods
X axis drive
 Clean and oil guide rails/guide carriage 7.7.5,
7.7.6
 Check tension of toothed/steel belt and readjust if necessary
 Check alignment of toothed/steel belt and readjust if necessary
 Check pivot bearing tension, adjust if necessary
 Clean and lubricate the gears
 Clean the drive belts
 Clean the drive and guide rollers
 Clean the chipping protection brush 7.7.9
Y axis drive
 Clean and oil the guide rails 7.7.7