User`s guide

Digital Rapids TouchStream
Page 4
Digital Rapids PCI Card Installation
CAUTION
Unplug the power supply cord from the source before removing a chassis cover.
Be sure to touch a grounded item before you touch any components inside the
chassis to discharge any static electricity from your body (for example, any
unpainted metal surface on a chassis that is still plugged in using a grounded
power cord).
The TouchStream chassis comes with the DRC capture board pre-installed.
Should you need to install a replacement board, install it in the same PCI slot.
Insert the replacement PCI card edge connector in the PCI slot while aligning the
end of the PCI card bracket in opening.
Firmly and slowly push the PCI card connector into the slot until it is fully seated.
Do not twist or bend the card while pushing it into the slot.
Fasten the PCI card‘s bracket into the case with the screw to ensure that the card
will not move.
Check the air flow in your chassis to make sure that cables have not moved in
such a way to block fans or air flow holes.