User`s guide

Digital Rapids TouchStream
Page 21
Audio Settings
The audio settings adjust the audio using the capture hardware that has been
integrated into the TouchStream. These settings can be pre-set before you start
encoding, or they can be adjusted on the fly during encoding.
Note that Audio Settings are global settings that are overwritten when you click
the Done button and return to the main screen. That is, the settings are not saved
with any individual project, they are saved and applied to all projects on the
TouchStream unit and to all output streams in the loaded project (if your project
includes more than one output stream).
Levels
The audio levels for each channel can be individually adjusted from the default of
0 dB (use the audio level of the source) up to +18 dB or down to -80 dB.
Note that you can also adjust the master audio level on the main screen,
adjusting all channels at once.
Bass/Treble
The Bass and Treble sliders can be used to adjust the levels from the default of 0
dB (use the level of the source) up to +18 dB or down to -18 dB.
Bass Treble settings are not available for the HDi (HD/SD SDI) models.
Info
When you press on the Info button you will see information about the currently
loaded project on the left side and information about the hardware and status on
the right hand side.
There are also two buttons. The Email button can be used to send information
about your unit to Digital Rapids Support should you need assistance. The
Network Settings button can be used to select between automatic and manual
network configuration.
Email Config
The Email Config button shows technical information about the unit that can be
used for troubleshooting. If you are having an issue with your unit and you
contact Digital Rapids Support for assistance they may direct you to use the
Email option on this Info screen. This will email the unit‘s information, along with
the project and input settings in use at the time, directly to Digital Rapids Support.