Product specifications

How to Install the Module
3-10 Installing the DIGITAL VNswitch 900FX
Task 3: Verify Initial LED Operation
To verify initial LED operation, check the following stages:
If... Then...
This is a new installation Turn on the power to the DIGITAL
MultiSwitch 900.
The module was installed while the
DIGITAL MultiSwitch 900 was
powered up
Seating the module initiates the module’s
power-up sequence.
If the LEDs do not operate as described,
refer to Appendix A, Problem Solving.
For locations of the module’s LEDs, refer
to Figure 3-1.
Stage Description
1 When the module receives power, the Power LED lights and remains
lit.
2 The module runs a self-test.
NOTE: The self-test takes approximately 3 minutes to complete.
3 After the module completes self-test, the Module OK LED lights.
4 The Chassis Manager status display identifies the module as the
VNswitch 900FX.