Product specifications

Installing the Card
2-4 Installing Modular Media Interface Cards
Installing the Card
To install a card into the module (Figure 2-2), complete the following steps:
Step Action
1 Attach one end of an antistatic wrist strap to your wrist and clip the other
end to the chassis ground (for example, a screw on the side of the
chassis).
CAUTION: Static electricity can damage modules and electronic
components. DIGITAL recommends using a grounded antistatic wrist
strap and a grounded work surface when handling any modules.
2 Remove the dust caps from the card, if necessary.
3 Hold the card by the edges on the bezel and position it so that it is
parallel with the slot opening.
4 Insert the card into the slot opening and slide the card along the card
guides until the bezel is flush with the module.
Note:
To prevent the screws from interfering with the card insertion,
make sure that the captive screws on the bezel are partially threaded
into the bezel threads.
5 Firmly fasten the card to the module with the two captive screws.