- Digital Networks Switch User Guide

DNswitch 800 Using Web-Based Management 7
Table 2-1. Areas of the User Interface
Table 2-2 describes configuration and system information functions
available In Area 2.
Table 2-2. Area 2 Functions
Area Function
1 Presents a graphical near real-time image of the front panel of the
selected switch. This area displays the switch’s ports, showing port
activity, duplex mode, or flow control, depending on the specified mode.
Various areas of the graphic can be selected for performing
management functions, including the ports, management, or the case.
2 Displays a list of links allowing you to go to the associated menu or
screen by selecting the item.
3 Presents system information based on your selection.
Function Description
System Provides basic system description, including contact information.
Switch Shows hardware/firmware version numbers and power status of the
switch.
IP Includes boot state, IP address, and Telnet session count.
SNMP Configures communities and trap managers; and activates traps.
Security Sets password for system access.
Upgrade Downloads new version of firmware to update your system.
Configure Allows you to save/restore the switch configuration to a file on a server.
Address Table Provides full listing or unicast addresses, sorted by address or VLAN.
STA Enables Spanning Tree Algorithm; also sets parameters for switch
priority, hello time, maximum message age, and forward delay; as well
as port priority and path cost.
Bridge
Extension
Displays/configures extended bridge capabilities provided by this
switch, including support for traffic classes, GMRP multicast filtering,
and VLAN extensions.
Priority Configures default port priorities and queue assignments.
VLAN
Management
Allows you to restrict management access to the switch to one VLAN.
VLAN Configures VLAN group members, automatic registration with GVRP,
and other port-specific VLAN settings.
IGMP Configures IGMP multicast filtering.
Port Enables any port, sets communication mode to auto-negotiation, full
duplex or half duplex, and enables/disables flow control.
Mirror Sets the source and target ports for mirroring.
Trunk Specifies ports to group into aggregate trunks.
Statistics Displays statistics on network traffic passing through the selected port.