User's Manual

1) Enter the current password.
2) Select ON of Install Lock
3) Enter new password
4) Confirm your new password by entering
new password again
5) Exit this menu and Turn off the DSR
6) Turn on DSR and press MENU
key on the RCU
7) Select any menu and press OK on the
RCU .
8) Then Enter Password Box will be dis-
played.
9) Unless enter correct password, you can
not run any menu.
Note : Default password is 0000
Warning : Do not forget your password in
order not to fail to operate DSR
★ How to use Install Lock
Factory Default
If you want to bring DSR back to the
factory default condition, select Factory
Default and press OK key.
Then, warning message will be displayed.
To confirm, select OK and press OK.
Warning : You will lose all of data and
information which was installed.
-29-
User Installation