User`s guide

32 XRSuper6 Appendix
Common Keypad Displays
Listed below are several keypad messages you may see on the display. Follow the instructions in the Possible Solutions column to
correct the problem. In most cases, you will need to call a service person to correct the problem.
Message
Ke
yp
ad
Tone
Meaning Possible Solutions
Invalid Code No
The user code you have entered is not
recognized by the system.
Check the user code and try again.
AC Trouble Yes The system is not getting proper power. Call your service person.
Battery Trouble Yes Battery is either low or missing. Call your service person.
Phone Line Trouble Yes
The panel is looking for phone jack
supervision.
Call your service person.
System Trouble or
Service Required
Yes
There is a
p
roblem with one or more of the
components in the system.
Call your service person.
System Busy No
The s
y
stem is
p
erformin
g
another task with
a higher priority.
Wait a few moments for the s
y
stem to finish the task. Call
y
our
service person if problem remains.
There is not a supervised device on bus.
No Low Voltage or an open yellow wire.
Two devices are on the same address.
Transmit Fail Yes
The panel has attempted to communicate
with the central station 10 times and has
not succeeded.
Make sure your telephone line is working properly. Call your
service person if problem remains.
Wireless Trouble Yes
The wireless receiver is not communicatin
g
with the 472 Inovonics 900MHz Interface.
Call your service person.
Non-Polled Address
770
Keypad
Only
Keypad is set to an invalid address. Call your service person.
4-Wire Bus Trouble Call your service person.