User`s guide

ManualsBrandsDigital Monitoring ManualsHome building and DecorXR6

30 XRSuper6 Appendix

Press To do this You will hear

# then 1 Arm all areas 3 short beeps

# then 2 Arm area 1 1 short beep

# then 3 Arm areas 1 & 2 2 short beeps

Note: Zones in a bad condition are force armed when the area arms.

# then 0 Disarm all areas 1 long beep

#, 5, 4, 0, n* Toggles the output 1 short beep = on

1 long beep = off

4 short beeps = restricted

1. _________________________ 3. _________________________

2. _________________________ 4. _________________________

Press To do this You will hear

# then 1 Arm all areas 3 short beeps

# then 2 Arm area 1 1 short beep

# then 3 Arm areas 1 & 2 2 short beeps

Note: Zones in a bad condition are force armed when the area arms.

# then 0 Disarm all areas 1 long beep

#, 5, 4, 0, n* Toggles the output 1 short beep = on

1 long beep = off

4 short beeps = restricted

1. _________________________ 3. _________________________

2. _________________________ 4. _________________________

PhoneAccess™ User's Guide

This exciting feature allows you to call your XRSuper6 system from any outside touch-tone phone to arm and disarm protection areas

or turn on or off the panel's relay outputs.

How it works

1. Call the system's phone number from a touch-tone phone.

2. The system answers the call and sounds a short ready tone.

You now have 8 seconds to enter a valid Master user code. If the

user code is accepted by the panel, you will hear one or more

beeps giving you the current armed status of the system. (Press

the * key at any time to hear the armed status of the system.)

If You will hear

All areas are armed 3 short beeps

Area 1 (Perimeter) is armed 1 short beep

Any area is armed 2 short beeps

All areas are disarmed 1 long beep

If the user code is not accepted by the panel, you will hear four

short beeps. Check the user code and try again. After 3

unsuccessful attempts, the panel locks out PhoneAccess™ until

a valid user code is entered at a keypad on the system.

3. Once the user code is accepted by the panel and the armed

status is given, you can enter the following commands:

Press For this action You will hear

#, 1 Arm all 3 short beeps

#, 2 Arm Perimeter 1 short beep

#, 3 Arm Perimeter/Interior 2 short beeps

#, 0 Disarm all areas* 1 long beep

#, 5, 4, 0, n* Toggles the output 1 short beep = on

1 long beep = off

4 short beeps = restricted

Quick Reference Wallet Card

(* Use outputs 1, 2, 3, or 4 in place of

(* Use outputs 1, 2, 3, or 4 in place of n)

(Enter output descriptions below)

(* Use outputs 1, 2, 3, or 4 in place of n)

(Enter output descriptions below)

Cut along dotted lines

PhoneAccess™ Quick Commands