User`s guide

XRSuper6 Arming and Disarming 9
Home/Away System Arming
Area Assignment: Your security system is divided into two or
three separate areas. Motion detectors, inside doors, and other
interior devices are assigned to an Interior and possibly Bedroom
area while windows and exterior doors, are assigned to a Perimeter
area.
Arming the system: When arming a Home/Away system, the keypad
displays HOME AWAY or HOME SLEEP AWAY. If you select
AWAY, you arm all areas of the system. You will want to arm all
areas when leaving with nobody staying inside. Selecting HOME
arms only the Perimeter of the system. Perimeter arming is for
when you are staying inside but want the comfort of knowing
the exterior doors and windows are armed. Selecting SLEEP
arms the Perimeter and Interior devices but leaves devices near
bedrooms and other nighttime areas off.
System Ready/System Not Ready Keypad
Displays
When all zones in the system are in a normal condition and can
be armed without bypassing, the keypad displays SYSTEM READY.
If there are one or more zones that are not in a normal condition,
the keypad displays SYSTEM NOT READY. Pressing any top row
Select key during this display shows the bad zone name.
Arming a Home/Away System
1. Enter your user code. The keypad displays HOME AWAY
or HOME SLEEP AWAY (you may have three areas).
2. Select HOME to arm the Perimeter only. Select SLEEP to arm
the Perimeter and Interior. Select AWAY to arm the
Perimeter, Interior, and Bedroom.
The keypad displays zones that have been bypassed prior to
arming and 24-hour zones that are in a bad condition. No
action is required by you.
3. At this point you can force arm or bypass any bad zones. A
zone that is force armed will be restored into the system if it
later returns to normal. A zone that is bypassed will remain
bypassed until the system is disarmed. See below.
3a. If a problem exists on any zones, the zone name and
problem are shown followed by: OKAY BYPASS STOP.
3b. Select OKAY to force arm the zone(s) before arming.
3c. Select BYPASS to bypass the zone(s) before arming.
3d. Select STOP to stop the system from arming. Correct the
zone problem(s) and return to step 1.
The keypad displays PERIMETER ON if you selected HOME, or
PERIM/INT ON if you selected SLEEP, or ALL SYSTEM ON if you
selected AWAY.
The keypad next displays EXIT: ## INSTNT and begins to count
down the number of seconds remaining for you to exit. When
the delay expires, all zones are armed.
4. You can select INSTNT while EXIT: ## INSTNT is displayed to
immediately arm all zones and make them instant. The keypad
displays INSTANT.
5. When the system is fully armed, the keypad displays PERIMETER
ON for Perimeter arming, PERIM/INT ON for Perimeter and
Interior arming, and ALL SYSTEM ON for all areas armed.