Specifications

XR6/XR10 Programming Guide Digital Monitoring Products
7
3 - COMMUNICATION
3.19 BACKUP REPORTING
YES enables this receiver to be a backup to the other receiver in the event the
other receiver cannot be reached.
3.20 FIRST TELEPHONE NUMBER
This is the first number the panel dials when sending reports to this receiver. A
phone number can consist of 15 characters in length. You can program a 3-second
pause in the dialing sequence by entering the letter P. You can program a dial tone
detect by entering the letter D. These characters are counted as part of the 15
allowable characters.
3.21 SECOND TELEPHONE NUMBER
The panel dials the second number when two successive tries using the first
number have failed. If the panel cannot reach the receiver after two attempts
using the second number, it returns to the first number and makes two additional
attempts. A total of ten dialing attempts are made using the first and second
phone numbers. If a second phone number is not entered, the first phone number
is used for all dialing attempts.
Each number can be up to 15 characters in length including any P or D characters
entered for pause and dial tone detect.
3.22 PAGER IDENTIFICATION NUMBER
Enter a pager identification number if your pager uses one. If it does, the panel
waits for nine seconds after having dialed the First Phone Number before sending
the Pager ID. After the Page ID has been sent, the panel waits another three
seconds before sending the actual pager message containing the panel reports.
BACKUP NO YES
FIRST PHONE NO.
–
SECOND PHONE NO.
–
PAGER I D NUMBER