Specifications

3 - COMMUNICATION
Digital Monitoring Products XR6/XR10 Programming Guide
6
3.11 OPENING/CLOSING AND USER REPORTS
Select YES to enable opening/closing, door access, schedule and code changes,
bypass, and zone reset reports by user to be sent to this receiver.
3.12 TEST REPORT
Select YES to enable the Recall Test report to be sent to this receiver. Reports are
sent according to the programming in section 3.7 Test Frequency.
3.13 BACKUP REPORTING
YES enables this receiver to be a backup to the other receiver in the event the
other receiver cannot be contacted.
3.14 FIRST TELEPHONE NUMBER
This is the first number the panel dials when sending reports to this receiver. A
phone number can consist of 15 characters in length. You can program a three-
second pause in the dialing sequence by entering the letter P. You can program a
dial tone detect by entering the letter D. These characters are counted as part of
the 15 allowable characters.
3.15 SECOND TELEPHONE NUMBER
The panel dials the second number when two successive tries using the first
number have failed. If the panel cannot reach the receiver after two attempts
using the second number, it returns to the first number and makes two additional
attempts. A total of ten dialing attempts are made using the first and second
phone numbers. If a second phone number is not entered, the first phone number
is used for all dialing attempts.
Each number can be up to 15 characters in length including any P or D characters
entered for pause and dial tone detect.
3.16 RECEIVER 2 PROGRAMMING
Repeat steps 3.9 through 3.15 when communicating to a second receiver. Receiver
2 defaults are set to NO.
If you select YES for any of the Receiver 2 options, you must have at least one
phone number programmed in Receiver 2 programming.
3.17 PAGER REPORTING
YES allows the panel to send Alarm, Trouble, Opening, and Closing reports to a
numeric pager. The panel uses DTMF tones to generate the account and report
information sent over the pager terminal equipment.
Selecting NO allows you to use the Receiver 2 Programming to send panel reports
to a second central station receiver.
3.17A ALARM REPORTS
Select YES to enable Abort, Alarm, Alarm Restoral, Ambush, Exit Error, and System
Recently Armed reports to be sent to this receiver or pager.
3.17B TROUBLE REPORTS
Select YES to enable supervisory, trouble, trouble restoral, force armed, and zone
fault reports to be sent to this receiver or pager.
3.17C OPENING/CLOSING REPORTS
Select YES to enable opening/closing, door access, schedule and code changes,
bypass, and zone reset reports by user to be sent to this receiver or pager.
3.18 TEST REPORT
Select YES to enable the Recall Test report to be sent to this receiver or pager.
Reports are sent according to the programming in section 3.7 Test Frequency.
BACKUP NO YES
O/C USER NO YES
TEST RPT NO YES
–
FIRST PHONE NO.
SECOND PHONE NO.
–
RECEIVER 2 PROG
PAGER? NO YES
ALARM NO YES
SPV TRBL NO YES
O/C USER NO YES
TEST RPT NO YES