Installation manual

XR6/XR3 Installation Manual Installing the RF connector
Issue 3.0 2009-07-15 Page 6-5
Stud Output Connector
1. Unpack the stud connector assembly. Remove the M6 nut, split washer and one flat washer
off the longer leg of the brass stud in the stud plate (Figure 6.4).
2. Position the stud plate on top of the transmitter over the large hole above the output strap.
3. Slide the brass stud through the hole in the output strap and re-attach the M6 nut, split
washer and flat washer.
4. Attach the stud plate on top of the transmitter with the four supplied M5 x 16 mm long pan
head screws, split and flat washers.
5. Close the Exciter Panel and reinstall all 11 mounting screws removed in “Preparation” on
page 6-1.
6. Close the front panel.
Figure 6.4: Stud-type Output Connector
M5x16 mm Pan Head Screws (4)
Stud Plate
Output Strap
M6 Brass Nut
Brass Stud
M6 Brass Nut