Installation guide

XR6/XR10 Installation Guide Digital Monitoring Products
1
INTRODUCTION
Panel Specifications
1.1 Power Supply
Transformer Input: 16.5 VAC 40VA (Models 320 wire-in or 321 plug-in)
16.5 VAC 20VA (Model 324 plug-in)
Standby Battery: 12 VDC 7.0Ah (40VA transformer charges up to 2 batteries)
Auxiliary Output: 12 VDC at 500mA
Bell Output: 12 VDC at 1.5 Amps with 40VA transformer, 600mA with 20VA transformer
Smoke Detector Output: 12 VDC at 100mA
All circuits inherent power limited
1.2 Communication
Built-in SDLC Digital Dialer communication to DMP Model SCS-1 Receivers
Built-in 4-2 communication to non-DMP receivers
Built-in CID (Contact ID) communication to non-DMP receivers
Any panel can operate as a local system.
1.3 Panel Zones
Nine 1k Ω EOL burglary zones (zones 1 to 9 on XR10, and zones 1 to 5 on XR6)
One 3.3k Ω EOL Class B powered fire zone with reset capability (zone 10 on XR10, and zone 6 on XR6)
1.4 Keypads
You can connect up to four supervised keypads to the XR6/XR10 panels.
• 16 or 32 character alphanumeric keypads
• 10-zone LED keypads
In addition, the following zone expanders can be added to the XR6 panel:
• Four and single point zone expanders
• Single point PIR and glassbreak detectors
• One 738A Ademco Wireless interface for up to 32 points of zone expansion
• One FA426 Wireless receiver for up to 16 points of zone expansion
1.5 Outputs
The XR6/XR10 panels provide four open collector outputs rated for 50mA each. A Model 300 Output Harness is required.
The open collector outputs provide the ground connection for a positive voltage source.
1.6 Enclosure Specifications
The XR6/XR10 panel ships in an enclosure with EOL resistors, battery leads, user's guide, and programming sheet.
Size: 12.5" W x 11.5" H x 3.5" D
Weight: 4 lbs
Color: Gray or Black
Construction: 20 gauge cold rolled steel