Installation guide

XR6/XR10 Installation Guide Digital Monitoring Products
13
INSTALLATION
13.2 FCC Registration
The panel complies with FCC part 68 and is registered with the FCC.
Registration number: CCKUSA - 18660 - AL - R
Ringer Equivalence: 1.1B
13.3 Notification
Registered terminal equipment must not be repaired by the user. In case of trouble, the device must be immediately
unplugged from the telephone jack. The factory warranty provides for repairs. Registered terminal equipment may not
be used on party lines or in connection with coin telephones. Notification must be given to the telephone company with
the following information:
a. The particular line(s) the service is connected to
b. The FCC registration number
c. The ringer equivalence
d. The make, model, and serial number of the device
13.4 Ground Start
To configure the panel for ground start operation, you must install the appropriate ground start module and program
one of the panel's available annunciator outputs for Ground Start operation. Refer to the panel Programming Guide for
complete programming information. This option must not be selected on a UL listed system.
Reset Jumpers J16
14.1 Description
There are two reset jumpers located at the top right of the panel's circuit board labeled RESET. Momentarily shorting
these jumpers allows you to reset the microprocessor. Resetting the panel allows you to enter the panel's internal
programmer.
To reset the panel when first installing the system, place the blade of a slotted screwdriver across the two reset
jumpers after applying power to the panel.
To reset the panel while the system is operational (for example, prior to reprogramming), you can short the jumpers
without powering down the system.
After resetting the panel for programming, you must begin within 30 minutes. If you wait longer than 30 minutes, you
will have to reset the panel again.