Specifications

31
Unit doesn’t power up • Check the connection of the power cord from the power supply to the wall
outlet and from the power supply to the machine.
•
Plug a lamp or radio into the wall outlet to verify that the outlet has power.
If a light switch controls the outlet, turn it on.
• If you have verified power from the outlet, you may have a faulty power
supply. Contact your local dealer for service.
Console displays an “Err” code •
An error code indicates a potentially faulty or improperly installed
component in your seated elliptical cross trainer. Contact your local dealer
for service.
Console blinks on / off •
Check the power cord connections. Make sure the connections are secure
from the power supply into the machine base and the wall outlet.
• Unplug and re-connect the console (you must remove the console back to
do this). When re-connecting the cable, make sure you feel the connector
snap into place or hear a click that indicates a proper connection.
• If the issue persists, contact your local dealer for service.
LED lights are always on •
Press and hold the Pause Clear button for five seconds to enter sleep
mode.
LED display is always toggling •
Press the Enter button to stop the LED screen from toggling.
Console LEDs are not bright
enough
•
Enter User Set-up, by pressing and holding the Level / keys for three
seconds.
•
Press any / key until “BRIT” displays in the matrix window.
•
Press Enter until the LEDs are set at the desired brightness (1-8).
• Press any / key until “EXIT” displays in the matrix window, then press
Enter.
• If the brightness is set to “8” (the brightest level) and the LEDs are still
dim, contact your local dealer for service.
Console does not “beep” when
buttons are pressed
•
Enter User Set-up by pressing and holding the Level / keys for three
seconds.
• Press any / key until “BEEP” displays in the matrix window.
• Press Enter until “On” is displayed.
• Press any / key until “EXIT” displays in the matrix window, then press
Enter.
• If “BEEP” is set to “On” and the issue persists, contact your local dealer
for service.
Console is in pause mode and
won’t “wake up”
•
Machine may be in MOM mode; press and hold the Program /– keys for
three seconds to deactivate MOM mode.
Don’t feel a resistance change •
Increase resistance level to 20 and pedal for 30 seconds. If you feel a
difference in the resistance, then the brake is working properly.
• Are the cables connected correctly? Unplug and re-connect the console
cable (you must remove the console back to do this). When re-connecting
the cable, make sure you feel the connector snap into place or hear a click
that indicates a proper connection.
• If the issue persists, contact your local dealer for service.
TROUBLESHOOTING & FAQs
Electronic Issues