User`s guide

LED Keypad User’s Guide
XR5 User’s Guide
13
Testing the System
It is good practice to test your system at least once each week.
This assures you that the system is working correctly and
identi es any potential problems.
Enter COMMAND + 4 + 1 to perform a system test. The bell
rings for 2 seconds then the battery and communications to the
central station are tested.
You can also initiate a System Test by pressing the TEST function
key followed by your User Code.
User Codes
Use this function to change the current User Code.
Press the CODE key followed by the current User Code. You
hear one beep if successful. Enter 0 (zero) + 1. Enter the new
4-digit User Code.
2-Button Fire Keys
If your system has a label showing a  ame under the TEST
and CODE keys, the optional Fire Panic key function has been
enabled.
Press the two keys over the icon, and hold them down for at
least 2 seconds. The system sends a Fire report to the central
station. The keypad beeps to con rm the Fire key entry.
SPECIAL
Pressing the
SPECIAL
key and entering the user code initiates
the Fire Drill function.
The Fire Drill sounds the alarm bells and keypad sounder for the
duration of the Bell Cutoff time. If the Bell Cutoff time is set to
zero (0), the Fire Drill continues until the bells are silenced by
entering a code. No keypad LEDs are turned on and no reports
are sent to the central station during the Fire Drill.
In the event of a real  re during a  re drill, the system sends a
report to the central station and the LED for any  re-detecting
zone glows red on the 692F.
Manual Fire Alarm
To manually initiate a Fire Alarm, press and hold the
TEST
and
CODE
keys simultaneously for about 2 seconds until the alarm
sounds.
Resetting Sensors
Use this function to reset smoke detectors after an alarm when
the Fire zone light is  ashing in alarm memory.
Enter COMMAND
+ 4 + 7
to perform a Sensor Reset. The system
resets the smoke detectors and stops the  ashing light if the
zone restores to normal.
You can also initiate a Sensor Reset by pressing the RESET
function key followed by your User Code.