Specifications

Digital Monitoring Products XR5 Programming Guide

inTroduCTion

1.3 Programming Menu

There are 8 programming menu items from which to choose:

Menu Item Section in this guide

Initialization 2

Communication 3

  

  

  

  

Stop 8

Set Lockout Code 9

To select a section for programming, press any top row Select keys when the keypad displays the name

of that section. Detailed instructions for each programming step are found in sections 2 through 9 of this

guide.

1.4 Programmer Lockout Codes

Although the XR5FC and XR5SL panels allow you to enter the built-in Programmer without a lockout

code, you may wish to program one to restrict programming access to only those persons your company

authorizes. You can do this by using the SET LOCKOUT CODE feature at the end of the programming menu.

Programming a Lockout Code

1. After entering the Programmer menu, the keypad displays PROGRAMMER

advance through the programming sections until SET LOCKOUT CODE displays (after Stop).

2. Press any top row Select key. At the ENTER CODE: - display, enter a 3 to 5-digit programmer lockout



3. The display shows ENTER AGAIN

display shows CODE CHANGED. The new code number must now be entered before accessing the

Programmer menu.

Write the lockout code number down and keep it in a secure place with access limited to authorized

persons only.

Lost Lockout Code requires factory reset: If you lose or forget the lockout code, the panel must be sent



lockout code.

1.5 Reset Timeout

The XR5FC and XR5SL has a feature that requires you to enter the Programmer within 30 minutes of



the keypad displays: RESET PANEL. You must reset the panel, enter the program code, then begin

programming within the next 30 minutes.

If you are already in the Programmer and do not press any keys on the programming keypad for 30 minutes,

the panel terminates programming. All data entered up to that point is saved in the panel memory.

Use the Stop routine to exit the panel Programmer.