Specifications

XR5 Programming Guide Digital Monitoring Products
11
ouTPuT oPTionS
Output Options
6.1
OUTPUT OPTIONS
Output Options


are available on the panel 6-position terminal strip. Annunciator outputs (open
collector) are available by using the 4-wire output header on the XR5FC and XR5SL
board. Refer to the XR5FC and XR5SL Installation Guide (LT-0299) for complete
information. A description of each output option follows:
6.2
BELL CUTOFF: 15
Bell Cutoff Time

silenced or the system is disarmed, the cutoff time resets. The Bell Cutoff Time can

6.3
BELL ACTION . . . . .
Bell Action


S. For a pulsed output, enter P. For
Temporal Code 3, enter T. For California School Code, enter C
enter N. Below is a list of the bell action for three of the zone types:
6.3.1
FIRE TYPE: P
Fire

6.3.2
SUPRVSRY TYPE: N
Supervisory

6.3.3
AUXLRY I TYPE: N
Auxiliary

6.4
OUTPUT ACTION . . .
Output Action

6.4.1
CO OUTS: - - - -
Cutoff Outputs
Any or all of the available outputs can be programmed here to turn off after the
OUTPUT CUTOFF TIME
disable this option, press any Select key to clear the display of output numbers and

6.4.2
CUTOFF TIME: 0
Output Cutoff Time

to remain on. If the output is turned off manually, the Cut off Time resets. The
Cutoff Time can be from 1 to 15 minutes.

The Cutoff Timer is shared by all outputs. If a second output trips, the timer is not
reset. Both outputs turn off when the original time expires.
6.4.3
COM FAIL OUT: 0
Communication Failure Output
This output is turned on when a DD system fails to communicate with the receiver
after ten successive dial attempts.
