Specifications

XR5 Programming Guide Digital Monitoring Products

CommuniCaTion
3.10
BACKUP NO YES
Backup Reporting
YES enables Receiver 1 to be a backup to Receiver 2 in the event the panel cannot
contact Receiver 2.
3.11
-
-
FIRST PHONE NO:
First Telephone Number
 
phone number can consist of two lines of 16 characters to equal 32 characters. You
can program a three second pause in the dial ing se quence by en tering the let ter P.
You can program a dial tone detect by entering the letter D. These characters are
counted as part of the 32 allowable characters.
3.12
-
-
SECOND PHONE NO:
Second Telephone Number
 
fail. If the panel cannot reach the receiver after two attempts using the second




entered for pause and dial tone detect.
3.13
RECEIVER 2 PROG
Receiver 2 Programming
Receiver 2 defaults are set to NO. If you select YES for any Receiver 2 options, you
must have at least one phone number programmed in Receiver 2 programming.
3.14
PAGER? NO YES
Pager Type
This option allows the panel to send Alarm and Trouble reports to a customer's
numeric pager. The panel uses DTMF tones for numeric pagers. Selecting NO allows
you to use the Receiver 2 Programming to send panel reports to a second receiver.
Note: The XR5 communicates in a half-duplex mode with a Glenayre alphanumeric
pager terminal. The terminal modem must accept the following parameters:
 
 
 
3.15
ALARM NO YES
Alarm Reports
See Receiver 1 Alarm Reports section for programming.
3.16
SPV/TRBL NO YES
Supervisory/Trouble Reports
See Receiver 1 Supervisory/Trouble Reports section for programming.
3.17
TEST RPT NO YES
Test Report
YES to enable the Recall Test report to be sent to this receiver. When 2nd
line is YES, the Recall Test message alternates between the two phone lines. The
message is sent on the phone line designated for that day even when the supervision
circuit indicates the phone line is bad. This allows both phone lines to be tested as

3.18
BACKUP NO YES
Backup Reporting
YES enables Receiver 2 to be a backup to Receiver 1 in the event the panel cannot
contact Receiver 1.