Programming instructions

Digital Monitoring Products XR500 Series Programming Guide
56
SToP
Stop
20.1
STOP
Stop
Save Programming
WHEN ANY PANEL PROGRAMMING IS CHANGED, THE STOP ROUTINE MUST BE RUN
AND ‘SAVING PROGRAM’ MUST DISPLAY ON THE KEYPAD IN ORDER TO SAVE THE
PROGRAMMING CHANGES.
AttheSTOPprompt,pressinganySelectkeyallowsyoutoexittheProgrammer
functionofthepanel.Whenselected,thepanelperformsaninternalresetand
exits the programmer.
TheSTOProutinecausesthefollowingconditionstooccur:
• All1100SeriesDMPWirelesstransmittersareresettoNORMAL
• ThepanelStatusListiscleared
During the reset, all keypad displays are momentarily blank for two seconds. After
the reset, the programming function terminates and the keypads return to the status
list display.
TheSTOPpromptdoesnotdisarmthesystem.Anynewareasorzonesthatwere
added during programming are not armed until the system is disarmed and armed
again.
Missing LX-Bus™ Modules Displayed
TheProgrammerincludesafeaturefollowingtheSTOProutinethatdisplaysthe
nameofanyprogrammedLX-Busmodulenotcurrentlyconnectedtothepanel.For
example,ifyouhadenabledanyLX-Busoptionsandnotyetinstalleda481LX-Bus
ExpansionCard,aftertheSTOProutinethepaneldisplaysNOLXBUSCARD.Thisisa
helpful reminder to install the card. This feature can also be a troubleshooting tool
to indicate a problem if you installed the card and this message still displays. The
followinglistshowsthedifferentmessagesandtheirassociatedLX-Buscards.
Keypad Display Missing Card
NO LXBUS CARD 481LX-Bus™ExpansionCard
NO PRINTER CARD 462P Printer Interface Card
NO HOST CARD 462N Network Interface Card
  (withNETWORKcommunicationselected)
The above messages clear automatically from the keypad after a few moments.
Power Up
WhentheXR500SeriespanelispoweredupafteranACpowerfailure,anyzone
transitions are not recognized for 60 seconds. Normal zone processing resumes at
the end of the 60 seconds.
Set Lockout Code
21.1
SET LOCKOUT CODE
Set Lockout Code
PressingCOMMANDattheSTOPpromptdisplaysSETLOCKOUTCODE.Thisallows
you to program a code that is then required to gain access to the panel internal
Programmer through the keypad. You can change this code at any time to any
combinationofnumbersfromthreetovedigitslong.Youdonotneedtoenter
leading zeros when using the lockout code. Initializing the panel does not clear a
LockoutCode.LockoutCodescanbechangedthroughRemoteLink.
Onceyouhavechangedthecode,itisimportanttowriteitdownsomewhereand
storeitinasafeplace.LostLockoutCodesrequirethepaneltobesentbackto
DMPforrepair.YoumaycancelaLockoutCodebyentering00000attheSetLockout
Code command.
Lockout Code restriction
DonotsetaLockoutCodehigherthan65535.
SeT loCkouT Code