User`s guide

Feature Set (XR500 Series or XR2500F only)
When you select an XR500 Series or XR2500F panel, the
Feature Set displays the available features and panel types.
Check the enabled features of the panel for the account you
are creating.
Click on Encryption when an XR500E panel is installed. The
encryption feature allows the XR500E to send and receive
data using 128 bit AES Rijndael encryption. To complete
encryption programming, your service provider needs to
enter an encryption Passphrase.
Click on XR2500F when an XR2500F Addressable Fire Alarm
Control Panel (FAPC) is installed.
Click on SVC USER AUTH to enable the option to authenticate service personnel before
allowing access to panel programming or the User Menu.
Main Receiver : Enter the receiver number with which the main panel account number
communicates. Usually this is set to 1 unless you have multiple receivers.
Main Account : Enter the account number of the panel that serves as the parent account
for this panel.
Receiver : Leave the Receiver field set to 1 unless you have multiple receivers.
Account : Enter the account number you wish to assign to this subscriber account. Only
numbers may be used for account numbers. Do not use letters when assigning account
numbers.
For the iCOM
SL enter an account number between 1 and 65535. In input mode, the account
number entered here is reported to the receiver.
In keypad mode, the account number reported to the receiver originates from the panel
attached to the iCOMsl. The account number entered here, when in keypad mode, is used
for programming with System Link only. The iCOM
SL and the panel have separate account
numbers.
When you are finish entering data into the fields in the New Panel window click OK to
close that window and go back to the Panel Information window. Click once on the line
with the panel that you just entered in the New Panel window.
Note: When assigning account numbers, keep the following conventions in mind.
When using DD (Digital Dialer) Communication, the range of available account numbers is
1 through 65535.
When using Modem IIe, Contact ID, or 4-2 communication, select an account number
between 1 and 9999.
When using Host/Net mode, the range of available account numbers is 1 and 65535.
When using Multiplex (MPX) communication, you must select a 5-digit account number.
The first number is the receiver line number, which is usually 1. The second number is
always 0. Assign three digits, between 000 and 127, as the main panel account number.
The full account number should read between 10000 and 10127. If you wish to assign
separate account numbers to individual areas, assign an area account number between 128
and 999. The final account number for areas should read between 10128 and 10999.
System Link User’s Guide
28