Installation guide

Digital Monitoring Products XT30/XT50 Installation Guide
14
InstallatIon
Flash Load Jumper J18
16.1 Description
TheXTSeriespanelsoftwarecanbeupdatedviathepanel’sprogramming(PROG)header.Toupdatethe
XT30/50panelwithanewsoftwareversion,completethefollowingstepsattheprotectedpremise:
1.PlaceajumperacrosstheReset(J16)headerandthenremovetheyellowandgreenwiresfromkeypad
busterminals8and9.
2.ConnectaDMP399CablefromtheJ8ProgrammingHeadertotheserialportofyourPCoperating
RemoteLinkandcontainingtheXTRUle.RequiresRemoteLink1.43orhigher.
3.StartRemoteLinkandcreateoropentheXTSeriescontrolpanelaccountthatmatchesthepaneltobeupdated.
4.SettheConnectionInformationTypetoDirectwithabaudrateof38400andchoosetheappropriateCOMport.
5.SelectPanel>RemoteUpdate,thenselectthecorrectRUlefortheXTpanelmodel.
6.WhileplacingashortacrosstheLOAD(J18)header,removethejumperfromtheReset(J16)header.
Click<Update>inRemoteLink.
7.Afterthesoftwareversionisupdated,removetheshortfromtheLOADheader.Placethejumper
acrossReset(J16)thenremovethe399cable.
8.Replacetheyellowandgreenwirestoterminals8and9.
9.RemoveReset(J16)jumpertoresumenormalpaneloperation.
Cellular Connections
17.1 Cellular
TheXT30/XT50Cellularoptionisavailablebuilt-inatthefactoryorasanoptionaladd-onmodule,Model
263G.TheJ19SMAcellularantennaconnectorisprovidedforthebuilt-incellularversionandprotrudes
through the top of the enclosure.
Ifthepanelisnotpurchasedwithbuilt-incellular,thentheJ24headerisprovidedtoconnecta263GDigital
CellularCommunicatorasanadd-on.The263GDigitalCellularCommunicatorprovidesacellularantenna
connectionthatprotrudesthroughthetopoftheenclosuresimilartoJ19.
Outputs
J11
1
2
3
4
J16
Reset
J20
1100 Series
Wireless Antenna
connection
J24 Celllular
headerfor
263G
connection
J19 Celllular
Antenna
connector
65555
Built-in Cellular
Module
Connect
antenna to
rightside
only
J18
Load
1100 Series
Antenna
(XT50)
J1
Ethernet
TX RX
WirelessLEDs
Programming
J8
XMIT
RCV
Figure 9: Cellular and 1100 Series Wireless Antenna Connections