Installation guide

XT30/XT50 Installation Guide Digital Monitoring Products
13
InstallatIon
13.2 FCC Registration
The panel complies with FCC part 68 and is registered with the FCC.
Registrationnumber:CCKAL00BXT50
RingerEquivalence:0.0B
13.3 Notication
Registered terminal equipment must not be repaired by the user. In case of trouble, the device must be
immediatelyunpluggedfromthetelephonejack.Thefactorywarrantyprovidesforrepairs.Registered
terminalequipmentmaynotbeusedonpartylinesorinconnectionwithcointelephones.Noticationmust
be given to the telephone company with the following information:
   a.Theparticularline(s)theserviceisconnectedto
b. The FCC registration number
c. The ringer equivalence
   d.Themake,model,andserialnumberofthedevice
Ethernet Connector J1
14.1 Description
TheEthernetConnector(J1)isavailableontheNetworkversionandconnectsdirectlytoanEthernet
networkusingastandardpatchcable.
14.2 Ethernet LEDs
ThetwoLEDs,locatedontheleftsideoftheJ1EthernetConnector,indicatenetworkoperation.Thetop,
LinkLEDisasteadygreenlightwhenanethernetcableisconnected.Thebottom,ActivityLEDashes
yellow to indicate messages are being received or transmitted.
Reset Header J16
15.1 Description
The reset header is located just above the terminal strip on the right side of the circuit board and is used
toresettheXT30/XT50microprocessor.Toresetthepanelwhenrstinstallingthesystem,installthereset
jumper before applying power to the panel. After connecting the AC and battery, remove the reset jumper.
To reset the panel while the system is operational, for example, prior to reprogramming, install the reset
jumper without powering down the system. Remove the reset jumper after one or two seconds.
Afterresettingthepanel,beginprogrammingwithin30minutes.Ifyouwaitlongerthan30minutes,you
must reset the panel again.
XT30/XT50 Panel
J3
Phone Line
Outputs
J11
1
2
3
4
J20
Wireless
Antenna
connection
J7 RJ
Supervision
J24 Celllular
header for
263G
connection
J19 Celllular
Antenna
connection
65555
Momentarily
place the Reset
jumper over both
of the J16 pins to
reset the panel.
J16
Reset
J18
Load
J1
Ethernet
OVC LED
Power
LED
TX RX
Wireless LEDs
Programming
J8
XMIT
RCV
Figure 9: Panel Showing the Reset Jumper Wires