User manual

DIGITAL-LOGIC AG MSM800SEV/SEL/BEV/XEV/XEL Detailed Manual V1.7
74
X15 LCD TFT Interface (flat panel signals)
Pin Signal TFT 18bit TFT 24bit
1 FPM (out) LDE LDE
2 CRT-Vert.Synch VSYNC VSYNC
3 Backlight Supply output (5/12V)*
4 CRT-Horiz.Synch HSYNC HSYNC
5 VCC 3.3V
6 Ground
7 NC
8 Shift Clock CKL CKL
9 VDD Supply output (3/5V)* ENLVDD ENLVDD
10 FP0 Blue 0
11 FP1 Blue 1
12 FP2 Blue 0 Blue 2
13 FP3 Blue 1 Blue 3
14 FP4 Blue 2 Blue 4
15 FP5 Blue 3 Blue 5
16 FP6 Blue 4 Blue 6
17 FP7 Blue 5 Blue 7
18 FP8 Green 0
19 FP9 Green 1
20 FP10 Green 0 Green 2
21 FP11 Green 1 Green 3
22 FP12 Green 2 Green 4
23 FP13 Green 3 Green 5
24 FP14 Green 4 Green 6
25 FP15 Green 5 Green 7
26 Ground
27 FP16 Red 0
28 FP17 Red 1
29 FP18 Red 0 Red 2
30 FP19 Red 1 Red 3
31 FP20 Red 2 Red 4
32 FP21 Red 3 Red 5
33 FP22 Red 4 Red 6
34 FP23 Red 5 Red 7
35 NC
36 Reserved PICR
37 Reserved VPIC
38 Reserved PIC_DAT
39 Reserved PIC_CLK
40 Reserved PIC_OSC1
41 Ground
42 NC
43 +5Volt Supply (out)
44 +12Volt Supply (out)
* Since board version V2.1, the
signals BKL (pin3) and VDD
(pin9) can be used directly,
without an external circuit
Pin Signal Name Supply Supply jumper Max. Current
3 BKL 5V 12V** R165 / R166 1.5A
9 VDD 3.3V 5V R163 / R164 1.5A
** The 12V will not generate on the board; you have to supply the
12V from an external PSU through the connector X1, pin4.
Please refer to the jumper list in Chapter 8 to install the supply jumpers correctly.