User manual

DIGITAL-LOGIC AG MSM800SEV/SEL/BEV/XEV/XEL Detailed Manual V1.7
111
J2 VGA Monitor (CRT-signals)
J2 Header 15 pins HiDensity DSUB
10 Pin -M Signal Pin Signal
2 VGA red 1 Red
4 VGA green 2 Green
6 VGA blue 3 Blue
8 Horizontal Synch 13 H-Synch
9 Vertical Synch 14 V-Synch
5 + 11 Bridged
1 Ground 5, 6, 7, 8 Ground
3 NC
5 NC
7 Serial_Data
10 Serial_Clock
The VGA-CRT signals from J2 must be wired to a standard VGA HiDensity DSub connector (female):
The LCD signals must be wired panel specific.
Solder-side view of the female 15pin HiDSub
1 2 3 4 5
Red Green Blue GND
6 7 8 9 10
GND
11 12 13 14 15
HSyn VSyn
J3 IDE Interface
Pin Signal Pin Signal
1 Reset (active low) 2 GND
3 D7 4 D8
5 D6 6 D9
7 D5 8 D10
9 D4 10 D11
11 D3 12 D12
13 D2 14 D13
15 D1 16 D14
17 D0 18 D15
19 GND 20 (keypin) NC
21 DREQ 22 GND
23 IOW (active low) 24 GND
25 IOR (active low) 26 GND
27 IORDY 28 ALE / Master-Slave
29 DACK 30 GND
31 IRQ14 32 NC
33 ADR1 34 NC
35 ADR0 36 ADR2
37 CS0 (active low) 38 CS1 (active low)
39 LED (active low) 40 GND
41 VCC Logic 42 VCC Motor
43 GND 44 NC