User`s manual

DIGITAL-LOGIC AG MSMP5 / P3 SEN/SEV Manual V1.6A
82
4.14 Video Input with the SAA7111 VIP
- Four analog inputs, internal analog source selectors, e.g. 4 CVBS or 2 Y/C or (1 Y/C and 2 CVBS)
- Two analog preprocessing channels
- Fully programmable static gain for the main channels or automatic gain control for the selected CVBS or Y/C channel
- Switchable white peak control
- Two built-in analog anti-aliasing filters
- Two 8-bit video CMOS analog-to-digital converters
- On-chip clock generator
- Line-locked system clock frequencies
- Digital PLL for horizontal-sync processing and clock generation
- Requires only one crystal (24.576 MHz) for all standards
- Horizontal and vertical sync detection
- Automatic detection of 50 and 60 Hz field frequency, and automatic switching between PAL and NTSC standards
- Luminance and chrominance signal processing for PAL BGHI, PAL N, PAL M, NTSC M, NTSC N, NTSC 4.43, SECAM
- User programmable luminance peaking or aperture correction
- Cross-colour reduction for NTSC by chrominance comb filtering
- PAL delay line for correcting PAL phase errors
- Real time status information output (RTCO)
- Brightness Contrast Saturation (BCS) control on-chip
- The YUV (CCIR-601) bus supports a data rate of:
- 864 fH = 13.5 MHz for 625 line sources
- 858 fH = 13.5 MHz for 525 line sources.
- Data output streams for 16, 12 or 8-bit width with the following formats:
– YUV 4 :1 :1 (12-bit)
– YUV 4 :2 :2 (16-bit) = used on the product
– YUV 4 :2 :2 (CCIR-656) (8-bit)
– RGB (5, 6, and 5) (16-bit) with dither
– RGB (8, 8, and 8) (24-bit) with special application.
- Odd/even field identification by a non interlace CVBS input signal
- Fix level for RGB output format during horizontal blanking
- 720 active samples per line on the YUV bus
- One user programmable general purpose switch on an output pin
- Built-in line-21 text slicer
- A 27 MHz Vertical Blanking Interval (VBI) data bypass programmable by I 2 C-bus for INTERCAST applications
- Power-on control
- Two via I 2 C-bus switchable outputs for the digitized CVBS or Y/C input signals AD1 (7 to 0) and AD2 (7 to 0)
- Chip enable function (reset for the clock generator and power save mode up from chip version 3)
- Compatible with memory-based features (line-locked clock)
- Boundary scan test circuit complies with the ‘IEEE Std. 1149.11990’ (ID-Code = 0 F111 02 B)
- I2C-bus controlled (full read-back ability by an external controller)
- Low power (0.5 W), low voltage (3.3 V), small package (LQFP64)
- 5 V tolerant digital I/O ports.