User`s manual

DIGITAL-LOGIC AG MSMP5 / P3 SEN/SEV Manual V1.6A

4.6.3 BIOS CMOS Setup

If wrong setups are memorized in the CMOS-RAM, the default values will be loaded after resetting the

RTC/CMOS-RAM with the CMOS-RESET jumper. If the battery is down, it is always possible to start the sys-

tem with the default values from the BIOS.

WARNING:

On the next setup pages (switch with TAB) the values for special parameters are modifiable. Normally the

parameters are set correctly by DIGITAL-LOGIC AG. Be very careful in modifying any parameter since the

system could crash. Some parameters are dependent on the CPU type. The cache parameter is always

available, for example. So, if you select too few wait states, the system will not start until you reset the

CMOS-RAM using the RAM-Reset jumper, but the default values are reloaded. If you are not familiar with

these parameters, do not change anything!

4.6.4 CMOS Setup Harddisk List

Use type 48 and type 49 for user defined harddisk entries. Enter the sectors, cylinders and the number of

heads. Select AUTODETECT in order to autoidentify the harddisk parameters.